Suunto VYTEC DS manual Tools Required, Transmitter Battery Replacement

CAUTION!

Defects caused by improper battery installation are not covered by the warranty.

BATTERY KIT

The transmitter battery kit includes a 3.0 V CR ˚ AA lithium cell battery and a lubricated O-ring. When handling the battery do not make contact with both of the poles at the same time. Do not touch the metal surfaces of the battery with your bare fingers.

TOOLS REQUIRED

•A Phillips head screwdriver

•Soft cloth for cleaning.

TRANSMITTER BATTERY REPLACEMENT

To change the transmitter battery, follow the procedure below:

1.Remove the transmitter from the regulator HP port

2.Unscrew and remove the four Phillips screws on the back of the transmitter

3.Pull off the transmitter cover

4.Carefully remove the o-ring. Be careful not to damage the sealing surfaces.

5.Carefully remove the battery. Do not touch the electrical contacts or the circuit board

Check for any traces of flooding, or for any other damage. In case of a leak or any other damage, bring the transmitter to an authorized SU- UNTO dealer or distributor for check and repair.

6.Check the condition of the O-ring; a defective O-ring may indicate sealing or other problems. Dispose the old O-ring, even if it seems to be in good condition.

7.Check that the o-ring groove and the sealing surface of the cover the are clean. Clean with soft cloth if necessary.

8.Gently insert the new battery in the battery compartment. Check the polarity of the battery: the “+” mark should point toward the top of the compartment and the “-” mark towards the bottom.

63