Timex W-195 manual Using the Dual Time Zone feature, Viewing the secondary time zone

NOTES:

•Be sure you have selected the intended time zone

(T1 or T2) before you begin setting; you cannot switch zones while setting (see “Using the Dual Time Zone feature” on pg 21).

•When setting the hour value, be sure to set to the correct part of the day (AM or PM) (12-hour format only).

•The seconds’ value can only be set to “0” and cannot be set individually for each time zone.

•The day of the week is automatically calculated based on the date.

•The watch will automatically adjust for leap years up to 2049.

•When the hourly chime is enabled, a confirmation beep will also be generated whenever a key is pressed.

Using the Dual Time Zone feature

The watch can keep track of the time for two zones

(T1 and T2). By default, T1 is the “primary” time zone (the one that you can see) and T2 is the “secondary” time zone (the one you can’t see). The indicator for the primary time zone is shown in the lower left of the display.

Viewing the secondary time zone

You may temporarily view (or “peek” at) the secondary time zone by briefly pressing and holding the STOP/RESET button. While you are “peeking” at the secondary time zone, its indicator (T1 or T2) will flash in the lower left-hand side of the display. When you release the STOP/RESET button, the watch will display the time for the primary time zone once again.

20 21