JVC RX-730R manual Searching for a Program by PTY Codes

TUNER DISPLAY MODE When pressing DISPLAY MODE on the remote control:

\

Remote: Inside

Make sure that you have selected FM station using the remote control only.

If not, the DISPLAY MODE button does not work for tuner operation. (Pressing TUNER (on the remote mode section of the inside panel) activates the remote control for tuner operation.)

Notes:

•If searching finishes at once, “PS”, “PTY”, and “RT” will not appear on the display.

•If you press DISPLAY MODE while listening to an AM (MW/LW) station, the display only shows station frequency.

•RDS is not available for AM (MW/LW) broadcasts.

English

See also page 39.

MENU

Searching for a Program by PTY Codes

	One of the advantages of the RDS service is that you can locate a particular kind of program from the preset
	channels by specifying the PTY codes.
	To search for a program using the PTY codes
PTY SEARCH	On the front panel:
	1. Press PTY SEARCH while listening to an FM station so that Control @/ # buttons work for
	selecting PTY code.
	“PTY” and “SELECT” alternate on the display.
	2. Press Control @/ # until the PTY code you want appears on the display.
	Each time you press the button, the display gives you the PTY codes described on page 25.
	3. Press PTY SEARCH again.
PTY SEARCH	While searching, “SEARCH” and the selected PTY code alternate on the display.
	The receiver searches 40 preset channels, stops when it finds the one you have selected, and tunes in
	that station.

To continue searching after the first stop:

PTY SEARCH	Press PTY SEARCH again while the indications on the display are flashing.
	If no program is found, “NOTFOUND” appears on the display.

	To stop searching any time during the process:
Front panel	Press PTY SEARCH while searching.

Page 24