JVC RX-730R manual Delay, If necessary, adjust the speaker output level as follows

English

Front panel

Front panel

Front panel

6.Press Control % / Þuntil “–DELAY +” appears on the display.

7.Press Control @/ # to adjust the delay time of the rear speaker output. Each time you press the button, the delay time changes as follows:

		DELAY 1	DELAY 2
		DELAY 4	DELAY 3
DELAY 1	Select this when the distance from you to your rear speakers is greater than that
	to the front speakers.
DELAY 2	Select this when the distance from you to your rear speakers is almost equal to
	that to the front speakers.
DELAY 3	Select this when the distance from you to your rear speakers is a little less than
	that to the front speakers.
DELAY 4	Select this when the distance from you to your rear speakers is much less than
	that to the front speakers.

Note:

When you have selected “3CHLOGIC,” you cannot adjust the delay time.

8. Press Control % / Þuntil “TEST” appears on the display, then press Control @/ # to start checking the speaker output balance.

“TEST” starts flashing on the display, and a test tone comes out of the speakers in the following order:

Left front speakerCenter speaker Right front speaker Rear speakers

Notes:

•No test tone comes out of the rear speakers when you have selected “3CHLOGIC.”

•No test tone comes out of the center speaker when you select “PHANTOM” or “OFF” for the center mode.

9.If necessary, adjust the speaker output level as follows:

•To adjust the rear speaker output level, press Control % / Þ until “– REAR +” appears on the display, then press Control @/ #.

•To adjust the center speaker output level, press Control % / Þuntil “–CENTER+” appears on the display, then press Control @/ #.

Notes:

•You cannot adjust the left and right rear speaker output level separately.

•You cannot adjust the rear speaker output level when you have selected “3CHLOGIC.”

•You cannot adjust the center speaker output level when you select “PHANTOM” or “OFF” for the center mode.

Page 33