English
Operating the Other Manufacturers’ Audio/Video Components
The remote control supplied with the receiver can learn and memorize the signals used for the other manufactures’ remote control unit. By storing these signals, you can operate the other manufacturers’ audio/ video components.
Storing the signals
Before storing another manufacturer’s signals, make sure that manufacturer’s remote control unit (hereafter called “target remote control”) actually works.
1Place the two remote controls on a level surface with signal transmitting windows facing each other.
Leave a space of 5 to 10 cm (2 to 4 inches) between the two remote controls; otherwise, storing may be failed.
5 to 10 cm | ERROR | AUDIO | SLEEP | C |
|
TV | KEY |
| |||
|
|
|
|
| |
(2 to 4 inches) | SEND/LEARN | VCR | SEQUENTIALPROGRAM | AB | TOUCHONE OPERATION |
|
|
|
|
|
2 Open the outside panel of this remote control.
LEARN CANCEL
Remote: Inside
EXT.1
TV VCR EXT.2
CD TAPE
3 Press LEARN so that the SEND/LEARN indicator lights up (green).
Lights
SEND/LEARNERROR
4Press one of the buttons on the remote mode section.
If possible, select the source corresponding to the target remote control’s usage.
SEND/LEARN ERROR
Remote: Inside
Buttons you can assign signals to
TV VCR
Remote: Outside
| DELAY | – CENTER + | |
1 | 2 | 3 | 4 |
| TEST | – REAR | + |
5 | 6 | 7/P | 8 |
FM
MODE/MUTE
9 10 0 +10
PRESET 
TV
CHANNELVOLUME
PTY SELECT |
| PTY SELECT |
|
– | PTY SEARCH | + | TV/VIDEO |
| DISPLAY MODE |
| TAPE |
|
|
|
Remote: Inside
Lights
SEND/LEARNERROR
Notes:
•Since no signal have been preset for the EXT.1 and EXT.2 modes, you can store signals from the target remote control without losing any preset signals.
•If you want to store a signal into the TV or VCR button on the POWER section, you can skip this step.
5Press one of the buttons (illustrated to the left), to which you want to assign a signal from the target remote control.
The SEND/LEARN indicator starts flashing.
SEND/LEARNERROR
Flashes
SEND/LEARNERROR
Note:
If the ERROR indicator lights red, you have already stored a signal. To change the stored signal, go to the next step. If you do not want to change it, press another button.
6While the SEND/LEARN indicator is flashing, press the button on the target remote control, the signal of which you want to assign to the button of this remote control you have pressed in step 5.
The SEND/LEARN indicator stops flashing and remains lit, and the ERROR indicator also lights red but soon goes off.
|
|
| SEND/LEARN | ERROR | |||||
Lights |
|
|
|
|
|
|
|
| Lights |
|
|
| SEND/LEARN | ERROR | |||||
Lights
SEND/LEARN ERROR
Page 47