JVC RX-730R manual Using stored signals, Press Learn to finish the storing procedure

LEARN CANCEL

Remote: Inside

After several seconds, the SEND/LEARN indicator goes off and lights up again. This means that the storing is successfully finished.

SEND/LEARN ERROR

Lights

SEND/LEARN ERROR

Notes:

•If the SEND/LEARN indicator stops flashing before you press the button on the target remote control, repeat from step 5 again.

•If the ERROR indicator lights red and does not go off, you have failed in storing the signal.

•If the ERROR indicator flashes, you have failed in storing the signal. Try again. However some signals do not match to this remote control even though this remote control can lean most infrared signals.

7Repeat steps 5 to 6 to store more signals in the same remote mode. Repeat steps 4 to 6 to store more signals in a different remote mode.

8Press LEARN to finish the storing procedure.

SEND/LEARN ERROR

Note:

The signals stored into this remote control from the target remote control deviates slightly from the original signals. Since some components will not accept these deviating signals, you may not be able to operate those components using this remote control even though the storing procedure has been successfully finished.

CAUTION:

When replacing the batteries, finish it without delay; otherwise, the stored signals are all erased.

English

Using stored signals

EXT.1

TV VCR EXT.2

CD TAPE

	DELAY	– CENTER +
1	2	3	4
	TEST	– REAR	+
5	6	7/P	8

FM

MODE/MUTE

9 10 0 +10

PRESET TV

CHANNELVOLUME

PTY SELECT		PTY SELECT
–	PTY SEARCH	+	TV/VIDEO
	DISPLAY MODE		TAPE

When you want to use the stored signals, follow the procedure below.

1Open the outside panel of the remote control.

2Press one of the remote mode buttons.

3Press the desired button.

Note:

When you have stored signals into the TV and VCR buttons, simply pressing the button will send the stored signals. You do not have to press a remote mode button.

TV VCR

Remote: Outside

Remote: Inside

Page 48