JVC RX-7010VBK manual For Canada/pour Le Canada

Page 3

For Canada/pour Le Canada

THIS DIGITAL APPARATUS DOES NOT EXCEED THE CLASS

B LIMITS FOR RADIO NOISE EMISSIONS FROM DIGITAL

APPARATUS AS SET OUT IN THE INTERFERENCE-CAUSING

EQUIPMENT STANDARD ENTITLED “DIGITAL APPARATUS,”

ICES-003 OF THE DEPARTMENT OF COMMUNICATIONS.

CET APPAREIL NUMERIQUE RESPECTE LES LIMITES DE

BRUITS RADIOELECTRIQUES APPLICABLES AUX APPAREILS

NUMERIQUES DE CLASSE B PRESCRITES DANS LA NORME

SUR LE MATERIEL BROUILLEUR; “APPAREILS

NUMERIQUES”, NMB-003 EDICTEE PAR LE MINISTRE DES

COMMUNICATIONS.

For Canada/pour le Canada

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE

BLADE OF PLUG TO WIDE SLOT, FULLY INSERT

ATTENTION: POUR EVITER LES CHOCS ELECTRIQUES,

INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA

BORNE CORRESPONDANTE DE LA PRISE ET POUSSER

JUSQUAU FOND

For U.S.A.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Caution: Proper Ventilation

Attention: Ventilation Correcte

To avoide risk of electric shock and fire and to protect from dam-

Pour éviter les chocs électriques, l’incendie et tout autre dégât.

age.

 

Disposer l’appareil en tenant compte des impératifs suivants

Locate the apparatus as follows:

Avant:

Rien ne doit gêner le dégagement

Front:

No obstructions open spacing.

Flancs:

Laisser 10 cm de dégagement latéral

Sides:

No obstructions in 10 cm from the sides.

Dessus:

Laisser 10 cm de dégagement supérieur

Top:

No obstructions in 10 cm from the top.

Arrière:

Laisser 15 cm de dégagement arrière

Back:

No obstructions in 15 cm from the back

Dessous:

Rien ne doit obstruer par dessous; poser l’appareil

Bottom:

No obstructions, place on the level surface.

 

sur une surface plate.

In addition, maintain the best possible air circulation as illustrated.

Veiller également à ce que l’air circule le mieux possible comme

 

Spacing 15 cm or more

illustré.

 

 

 

 

Dégagement de 15 cm ou plus

Wall or obstructions

Mur, ou obstruction

Front

Avant

RX-7010VBK

Stand height 15 cm or more

Hauteur du socle: 15 cm ou plus

Floor Plancher

Image 3
Contents RX-7010VBK Mises en garde, précautions et indications diverses For Canada/pour Le Canada Table of Contents Front Panel Remote ControlEx. When you press CD button Parts IdentificationGetting Started Before InstallationConnecting the FM and AM Antennas Checking the Supplied AccessoriesAM Antenna Connections Connecting the SpeakersBasic connecting procedure Connecting the front speakersAbout the speaker impedance Connecting Audio/Video ComponentsConnecting the subwoofer speaker Connecting the rear and center speakersCassette deck or CD recorder CD playerTo audio output Video component connectionsDBS tuner TV and/or DBS tunerTo audio OutputDigital connections Digital input terminalsDigital output terminal R6PSUM-3/AA15F Connecting the Power CordPutting Batteries in the Remote Control Plug the power cord into an AC outletTurning the Power On and Off Standby Basic OperationsSelecting the Source to Play Selecting different sources for picture and sound Adjusting the VolumeListening only with headphones Selecting the Front SpeakersMuting the Sound Attenuating the Input SignalAdjusting the Tone Adjusting the Subwoofer Output LevelChanging the Source Name Basic SettingsAdjusting the Front Speaker Output Balance Recording a SourceSetting the Speakers for the DSP Modes Setting the Subwoofer InformationTo select the delay time of the rear speaker output LFE ATT Low Frequency Effect Attenuator appears on DisplayCrossover FRQ Crossover Frequency appears on the display Selecting the Analog or Digital Input Mode Digital Input Digital in Terminal SettingUsing the Sleep Timer Storing the Basic Settings AdjustmentsTuning in Stations Manually Using Preset TuningReceiving Radio Broadcasts Selecting the FM Reception Mode Using the DSP Modes What are the DSP Modes?Surround modes DAP modes DVD Multi Playback ModeAvailable DSP modes according to the input mode Reproducing the Sound FieldAvailable DSP Modes According to the Speaker Arrangement Available DSP modesBy pressing Surround on By pressing DSP MODE, Adjusting the Surround Modes Level you want Press DSP Mode repeatedly untilAdjust the effect level Press Effect to select an effectDance CLUB, HALL, or Pavilion appears on Display Adjusting the DAP ModesDAP mode Live Club Adjust the rear speaker output levelsPress Surround ON/OFF To cancel the Dolby/DTS Surround modeTo cancel the DSP mode Activating the DSP ModesMulti appears on the display Using the DVD Multi Playback ModeActivating the DVD Multi Playback Mode Press DVD Multi so that DVDAutomatic Source Selection Compu Link Remote Control SystemRemote Control through the Remote Sensor on the Receiver Synchronized RecordingTerminals Video terminals AV Compu Link Remote Control SystemAV Compu Link terminal on the rear panel CASE1 If the components are equipped with the S-videoOne-Touch DVD Play Automatic Selection of TV’s Input ModeAutomatic Power On/Off One-Touch Video PlaySound control section Amplifier Operating JVC’s Audio/Video ComponentsOperating Audio Components TunerREW CD changerTurntable Cassette deckPLAY3 Operating Video ComponentsDVD player Stops playing temporarily. To release it, pressOperating Other Manufacturers’ Video Equipment Press and hold TV PowerEnter manufacturer’s code using buttons Release TV PowerRelease CATV/DBS Power For Catv converterFor DBS tuner Release VCR Power Try to operate your VCR by pressing VCR PowerIf there are more than one code listed for your brand 04, 05 Release Audio PowerPlay JVC Denon Panasonic Philips PioneerProblem Possible Cause Solution TroubleshootingVideo SpecificationsAmplifier AudioGeneral Tuning Range Usable Sensitivity Signal-to-Noise RatioFM tuner IHF AM tunerValley Road Wayne, NJ QualityserviceFactory Service Center Locations 781 954 650Limited Warranty AUDIO-2 0101NHMMDWJEIN