AM Antenna Connections
|
|
|
| Snap the tabs on the loop into the |
|
| slots of the base to assemble the | ||
ANTENNA | ||||
|
| FM 75 | AM loop. | |
|
| COAXIAL |
| |
|
|
|
|
|
AM
LOOP
AM |
| AM Loop Antenna |
EXT |
|
|
1 | 2 | 3 |
Outdoor single
Turn the loop until you have the best reception.
Notes:
• If the AM loop antenna wire is covered with vinyl, remove the vinyl by twisting it as shown in the diagram.
•Make sure the antenna conductors do not touch any
other terminals, connecting cords and power cord. This could cause poor reception.
•If reception is poor, connect an outdoor single
Basic connecting procedure
1 | 2 |
| 3 | 4 |
|
| 1 | 1 | 1 |
|
|
| ||
| RIGHT |
| RIGHT | RIGHT |
|
|
|
|
1Cut, twist and remove the insulation at the end of each speaker signal cable (not supplied).
2Turn the knob counterclockwise.
3Insert the speaker signal cable.
4Turn the knob clockwise.
Connecting the front speakers
You can connect two pairs of front speakers (one pair to the FRONT SPEAKERS 1 terminals, and another pair to the FRONT SPEAKERS 2 terminals).
12
Right speaker | Right speaker |
Connecting the Speakers
You can connect the following speakers:
•Two pairs of front speakers to produce normal stereo sound.
•One pair of rear speakers to enjoy the surround effect.
•One center speaker to produce more effective surround effect (to emphasize human voices).
•One subwoofer to enhance the bass.
IMPORTANT:
After connecting the speakers listed above, set the speaker setting information properly to obtain the best possible DSP effect. For details, see page 14.
For each speaker (except for a subwoofer), connect the (+) and
CAUTION:
Use speakers with the SPEAKER IMPEDANCE indicated by the speaker terminals.
1 | FRONT | 2 |
|
SPEAKERS |
| ||
FRONT | + | + | FRONT |
|
| ||
SPEAKERS | – | – | SPEAKERS |
1 | 2 | ||
| RIGHT | LEFT |
|
RIGHT | LEFT |
|
|
Left speaker | Left speaker |
4