Adjusting the DAP Modes
Once you have adjusted the DAP modes, the adjustment is memorized for each DAP mode.
Before you start, remember...
• Make sure that you have set the speaker information correctly |
(see page 14). |
• There is a time limit in doing the following steps. If the setting is |
canceled before you finish, start from step 1 again. |
From the remote control:
1. Press DSP MODE repeatedly until | DSP |
the DAP mode — LIVE CLUB, | MODE |
| |
DANCE CLUB, HALL, or |
|
PAVILION — appears on the |
|
display. |
|
The DSP indicator also lights up on the display.
• You cannot adjust the rear speaker output level when you have set |
“REAR SPK” to “NO.” See page 14. |
On the front panel:
1. Press DSP MODE repeatedly until DSP MODE the DAP mode — LIVE CLUB, 
DANCE CLUB, HALL, or
PAVILION — appears on the display.
The DSP indicator also lights up on the display.
2. Adjust the rear speaker output levels.
1) Press ADJUST repeatedly until one of | ADJUST SETTING |
the following indications appears on |
|
the display. |
|
“REAR L LEVEL”:
To adjust the left rear speaker level. “REAR R LEVEL”:
2. Press SOUND.
The 10 keys are activated for sound adjustments.
3.Adjust the rear speaker output levels.
•To adjust the left rear speaker level, press REAR•L +/– (from +10 dB to
•To adjust the right rear speaker level, press REAR•R +/– (from +10 dB to
4.Press EFFECT to select an effect level you want.
•Each time you press the button, the effect level changes as follows:
SOUND
– REAR• L+
5 6
ENTER
– REAR• R+
8 
9
EFFECT
1
To adjust the right rear speaker level.
2) | Press CONTROL UP 5/DOWN °to | CONTROL |
| adjust the selected speaker output level | DOWN UP |
|
| |
| (from +10 dB to |
|
3) | Repeat 1) and 2) to adjust the other |
|
| speaker output level. |
|
DSP EFFECT 1 
DSP EFFECT 2 
DSP EFFECT 3
DSP EFFECT 5 | DSP EFFECT 4 |
As the number increases, the selected DAP mode becomes stronger (normally set it to “DSP EFFECT 3”).
3.Adjust the effect level.
1)Press ADJUST repeatedly until “DSP EFFECT” appears on the display. The display changes to show the current setting.
2)Press CONTROL UP 5/DOWN °to select the effect level.
•Each time you press the button, the effect level changes as follows:
ADJUST SETTING
CONTROL
DOWN UP
DSP EFFECT 1
DSP EFFECT 2 
DSP EFFECT 3 
DSP EFFECT 5 | DSP EFFECT 4 |
As the number increases, the selected DAP mode becomes stronger (normally set it to “DSP EFFECT 3”).
25