JVC RX-7010VBK FM tuner IHF, AM tuner, Tuning Range Usable Sensitivity Signal-to-Noise Ratio

Page 43

FM tuner (IHF)

Tuning Range:

Usable Sensitivity:

50 dB Quieting Sensitivity:

Signal-to-Noise Ratio (IHF-A weighted):

Total Harmonic Distortion:

Stereo Separation at REC OUT:

Alternate Channel Selectivity:

Frequency Response:

AM tuner

Tuning Range:

Usable Sensitivity:

Signal-to-Noise Ratio

General

Power Requirements:

Power Consumption:

Dimensions (W x H x D):

Mass:

87.5 MHz to 108.0 MHz

 

Monaural:

12.8 dBf (1.2 µV/75

Ω)

Monaural:

21.3 dBf (3.2 µV/75

Ω)

Stereo:

41.3 dBf (31.5 µV/75

Ω)

Monaural:

78 dB at 85 dBf

 

Stereo:

73 dB at 85 dBf

 

Monaural:

0.4% at 1 kHz

 

Stereo:

0.6% at 1 kHz

 

35 dB at 1 kHz

45 dB: (±400 kHz)

30 Hz to 15 kHz: (+0.5 dB, –3 dB)

530 kHz to 1 710 kHz

Loop antenna

400 µV/m

 

50 dB (100 mV/m)

AC 120V , 60 Hz

180 W/230 VA (at operation)

2 W (in standby mode)

435 mm x 146.5 mm x 425.5 mm (17 3/16 in. x 5 13/16 in. x 16 13/16 in.)

8.6 kg (19.0 lbs)

Designs & specifications are subject to change without notice.

40

Image 43
Contents RX-7010VBK Mises en garde, précautions et indications diverses For Canada/pour Le Canada Table of Contents Front Panel Remote ControlEx. When you press CD button Parts IdentificationGetting Started Before InstallationConnecting the FM and AM Antennas Checking the Supplied AccessoriesAM Antenna Connections Connecting the SpeakersBasic connecting procedure Connecting the front speakersAbout the speaker impedance Connecting Audio/Video ComponentsConnecting the subwoofer speaker Connecting the rear and center speakersCassette deck or CD recorder CD playerTo audio output Video component connectionsDBS tuner TV and/or DBS tunerTo audio OutputDigital input terminals Digital connectionsDigital output terminal R6PSUM-3/AA15F Connecting the Power CordPutting Batteries in the Remote Control Plug the power cord into an AC outletBasic Operations Turning the Power On and Off StandbySelecting the Source to Play Selecting different sources for picture and sound Adjusting the VolumeListening only with headphones Selecting the Front SpeakersMuting the Sound Attenuating the Input SignalAdjusting the Tone Adjusting the Subwoofer Output LevelChanging the Source Name Basic SettingsAdjusting the Front Speaker Output Balance Recording a SourceSetting the Speakers for the DSP Modes Setting the Subwoofer InformationLFE ATT Low Frequency Effect Attenuator appears on Display To select the delay time of the rear speaker outputCrossover FRQ Crossover Frequency appears on the display Selecting the Analog or Digital Input Mode Digital Input Digital in Terminal SettingUsing the Sleep Timer Storing the Basic Settings AdjustmentsUsing Preset Tuning Tuning in Stations ManuallyReceiving Radio Broadcasts Selecting the FM Reception Mode What are the DSP Modes? Using the DSP ModesSurround modes DAP modes DVD Multi Playback ModeAvailable DSP modes according to the input mode Reproducing the Sound FieldAvailable DSP modes Available DSP Modes According to the Speaker ArrangementBy pressing Surround on By pressing DSP MODE, Adjusting the Surround Modes Level you want Press DSP Mode repeatedly untilAdjust the effect level Press Effect to select an effectDance CLUB, HALL, or Pavilion appears on Display Adjusting the DAP ModesDAP mode Live Club Adjust the rear speaker output levelsPress Surround ON/OFF To cancel the Dolby/DTS Surround modeTo cancel the DSP mode Activating the DSP ModesMulti appears on the display Using the DVD Multi Playback ModeActivating the DVD Multi Playback Mode Press DVD Multi so that DVDAutomatic Source Selection Compu Link Remote Control SystemRemote Control through the Remote Sensor on the Receiver Synchronized RecordingTerminals Video terminals AV Compu Link Remote Control SystemAV Compu Link terminal on the rear panel CASE1 If the components are equipped with the S-videoOne-Touch DVD Play Automatic Selection of TV’s Input ModeAutomatic Power On/Off One-Touch Video PlaySound control section Amplifier Operating JVC’s Audio/Video ComponentsOperating Audio Components TunerREW CD changerTurntable Cassette deckPLAY3 Operating Video ComponentsDVD player Stops playing temporarily. To release it, pressOperating Other Manufacturers’ Video Equipment Press and hold TV PowerEnter manufacturer’s code using buttons Release TV PowerFor Catv converter Release CATV/DBS PowerFor DBS tuner Try to operate your VCR by pressing VCR Power Release VCR PowerIf there are more than one code listed for your brand 04, 05 Release Audio PowerPlay JVC Denon Panasonic Philips PioneerProblem Possible Cause Solution TroubleshootingVideo SpecificationsAmplifier AudioGeneral Tuning Range Usable Sensitivity Signal-to-Noise RatioFM tuner IHF AM tunerValley Road Wayne, NJ QualityserviceFactory Service Center Locations 781 954 650Limited Warranty AUDIO-2 0101NHMMDWJEIN