7.Press three 50mm Square Inner Caps (36) into the Leg Lever (32). Press a 1” Round Inner Cap (41) into the Leg Lever. Press a 1” Angle Cap (5) onto the Leg Lever.
8.Lubricate the M10 x 75mm Bolt (10). Attach the Leg Lever (32) to the Front Leg (22) with the Bolt and an M10 Nylon Locknut (14).
9.Tap 3/4” Round Inner Caps (43) into each end of the three Pad Tubes (38).
Insert a Pad Tube (38) through one hole in the Leg Lever (32). Insert another Pad Tube through the other hole in the Leg Lever. Insert the remaining Pad Tube through the upper hole in the Front Leg (22).
Slide two Foam Pads (48) onto each Pad Tube (38).
10.Set each section of the Base (20, 55) on the floor. Be sure that the indented side of each section of the Base is facing the floor. Press a 50mm Square Inner Cap (36) into the indicated end of each sec- tion of the Base.
Insert four M8 x 58mm Carriage Bolts (6) into each section of the Base (20, 55).
8
7 |
|
|
|
| 36 |
|
|
|
|
| 32 |
|
|
| 5 |
| 41 |
|
|
|
|
| 36 |
8 |
|
|
|
| 14 |
|
|
| 32 |
|
|
|
|
| |
|
|
| 22 |
9 | 48 |
|
|
| 43 | Upper | |
| 38 | ||
|
| Hole | |
48 | 43 |
| 22 |
43 |
|
| 48 |
| 38 |
| |
|
|
| |
|
|
| 43 |
| 48 |
|
|
|
|
| 48 |
| 32 |
| 38 |
|
| 43 | |
|
|
| |
10 | 20 |
|
|
|
|
| |
|
| 6 |
|
| 6 |
| 55 |
|
|
| |
|
|
| 6 |
36 |
| 6 | The indented |
|
| ||
|
|
| side must face |
|
|
| the floor |