Weider WEBE37330 user manual Holes

Page 10

13.Attach a Rear Upright (43) to the Left Base (40) with two M10 x 78mm Bolts (32) and two M10 Nylon Locknuts (34). Note: The Rear Uprights are shorter than the Front Uprights (not shown). Make sure the holes are on the side shown. Do not tighten the Locknuts yet.

Repeat this step with the other Rear Upright (43) and the Right Base (38).

14.Press a 60mm Square Inner Cap (64) into the top of the Left Front Upright (44).

Attach the Left Front Upright (44) to the Left Base

(40)with four M10 x 78mm Bolts (32), two Rack Joint Plates (85), and two M10 Nylon Locknuts

(34).Do not tighten the Locknuts yet.

Make sure the holes on the Left Front Upright

(44)face the holes on the Rear Upright (43), and that the numbers on the Left Front Upright face the numbers on the Right Front Upright (not shown).

Repeat this step with the right Front Upright (not shown) and the Right Base (38).

13
	43
	43
	Holes
	34
38	32
	40
14
	64
	43
38
	44
	Holes
	Numbers
32	32
32
	85
	40
	85
	34
	34

10

Image 10

Contents Model No. WEBE37330 Serial No QUESTIONS?Customer HOT Line Table of Contents Decal Important Precautions Right Side Before YOU BeginLeft Side Make Things Easier for Yourself AssemblyDo not tighten the Locknuts yet Locknuts 34. Do not tighten the Locknuts yet Other Small Base Cap in the same mannerTighten the M10 Nylon Locknuts 34 used Steps Page Assemble the other Pad Tube 27 in the same manner Locknuts yet Repeat this step with the Right Base not shownHoles 110 Tighten the Locknuts yet Locknuts yet Tighten the M10 Nylon Locknuts 34 used Steps Right Safety Spotter not shown in the same Manner Locate the Medium Cable 69. Route the Cable Cable Trap is oriented to hold the Cable Locate the Butterfly Cable 109. AttachGroove of the Pulley Is shown pulled away from the Center Upright for clarity Seat 10 can be adjusted in the same man- ner AdjustmentsAdjusting the Backrest and Seat Attaching the Curl PAD or LEG LeverAttaching the Accessories Adding Weight to the LEG LeverAdding Weight to the Weight Carriage Using the AB SlingsAttaching the DIP ARM Using the Weight Rests and Safety SpottersSetting UP for Squat Exercises Knobs 22 are fully tightenedMoving the Bench Tightening the CablesButterfly Cable Cable DiagramsMedium Cable Long CableExercise Guidelines Cooling Down Muscle ChartStaying Motivated Aerobic Exercise Exercise Weight Sets RepsDate Thursday Aerobic Exercise DateMonday Part Identification CHART-Model No. WEBE37330 R0803BPage 48mm Weight Carriage Cap Part LIST-Model No. WEBE37330 Qty DescriptionExploded DRAWING-Model No. WEBE37330 Exploded Limited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT