Weider WEBE37330 user manual Locknuts yet

Page 13

20.Press a 60mm Square Inner Cap (64) into the Weight Guide Base (41).

Attach the Foot Plate (67) and the Weight Guide Base (41) to the Center Base (39) with two M10 x 81mm Button Bolts (104) and two M10 Nylon Locknuts (34). Do not tighten the Locknuts yet.

21.Attach the Center Top Frame (46) to the Left Top Frame (48) with two M10 x 78mm Bolts (32) and two M10 Nylon Locknuts (34). Make sure the decal is in the indicated location. Do not tight- en the Locknuts yet.

Attach the Center Top Frame (46) to the Right Top Frame (47) with two M10 x 78mm Bolts (32) and two M10 Nylon Locknuts (34). Do not tight- en the Locknuts yet.

22.Slide the Weight Carriage Stop (65) onto the Weight Guide Upright (42) as shown, and attach it at the indicated hole with an M10 x 87mm Bolt (106) and an M10 Nylon Locknut (34).

Attach the Weight Guide Upright (42) to the Weight Guide Base (41) with two M10 x 75mm Bolts (92), four M10 Washers (35), and two M10 Nylon Locknuts (34). Do not tighten the

Locknuts yet.

20		64
		64
		34
		41
67		34
67
		39
104
21
34
		46
47
		Decal
32		34
		32
		48
22
	42
34	35
		Hole
34		35
34	35
		92
		Hole closer
65		to bottom
		106
		41

13

Image 13

Contents Model No. WEBE37330 Serial No QUESTIONS?Customer HOT Line Table of Contents Decal Important Precautions Right Side Before YOU BeginLeft Side Make Things Easier for Yourself AssemblyDo not tighten the Locknuts yet Locknuts 34. Do not tighten the Locknuts yet Other Small Base Cap in the same mannerTighten the M10 Nylon Locknuts 34 used Steps Page Locknuts yet Repeat this step with the Right Base not shown Assemble the other Pad Tube 27 in the same mannerHoles 110 Tighten the Locknuts yet Locknuts yet Tighten the M10 Nylon Locknuts 34 used Steps Right Safety Spotter not shown in the same Manner Locate the Medium Cable 69. Route the Cable Cable Trap is oriented to hold the Cable Locate the Butterfly Cable 109. AttachGroove of the Pulley Is shown pulled away from the Center Upright for clarity Adjusting the Backrest and Seat AdjustmentsSeat 10 can be adjusted in the same man- ner Attaching the Curl PAD or LEG LeverAdding Weight to the Weight Carriage Adding Weight to the LEG LeverAttaching the Accessories Using the AB SlingsSetting UP for Squat Exercises Using the Weight Rests and Safety SpottersAttaching the DIP ARM Knobs 22 are fully tightenedTightening the Cables Moving the BenchMedium Cable Cable DiagramsButterfly Cable Long CableExercise Guidelines Cooling Down Muscle ChartStaying Motivated Date Exercise Weight Sets RepsAerobic Exercise Thursday Aerobic Exercise DateMonday R0803B Part Identification CHART-Model No. WEBE37330Page 48mm Weight Carriage Cap Qty Description Part LIST-Model No. WEBE37330Exploded DRAWING-Model No. WEBE37330 Exploded Limited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT