Weider WESY97300 Locate the Low Cable, Slide the Low Cable into place under the 3 1/2 Low Pulley

CABLE ASSEMBLY

26. Attach the 3 1/2” Low Pulley (88) and the 5/8”				26
	x 9/16” Spacer (73) to the indicated hole in
	the Press Frame (17) with a 3/8” x 3 3/4” Bolt
	(71), and a 3/8” Washer (9).		Be sure that the
	3/8” x 3 3/4” Bolt (71), the 3/8” Washer
	(9), the 5/8” x 9/16” Spacer (73), the 3 1/2”
	Low Pulley (88), and the 3/8” Nylon
	Locknut (21) are oriented as shown.
						9	71
						17
							73
							88
27.	Locate the Low Cable (86).		Slide the Low	27
	Cable into place under the 3 1/2” Low Pulley				21
	(88).Be sure that the end of the Cable with
	the ball is on the indicated side of the
	Press Frame (17) and that the Cable is					71
	between the Pulley and the crossbar on					88
	the Press Frame.	Fully tighten a 3/8” Nylon				Ball
	Locknut (21) onto the 3/8” x 3 3/4” Bolt (71).
	Note: You may need to remove the 3 1/2”					Crossbar
	Low Pulley (88) from the 3/8” x 3 3/4” Bolt
	(71) to properly route the Low Cable (86).			86	17
28. Wrap the Low Cable (86) around a 3 1/2”				28
	Pulley (15). Attach the Pulley and a Cable					21
					66
	Trap (66) to the lower hole in the Front
	Upright (42) with a 3/8” x 3 3/4” Bolt (71), a
	3/8” Washer (9), and a 3/8” Nylon Locknut
	(21). Be sure that the Cable Trap is turned
	to hold the Cable in place and that the						86
	Cable is routed around the Pulley as				15
	shown.
				9	42
				71

14