Weider WESY74090 user manual Cable Diagram, Shooting and Maintenance on

Page 15

30.Press a 3/4” Round Inner Cap (34) into each end of the Pad Tube (28).

Insert the Pad Tube (28) through the indicated hole in the Leg Lever (29). Slide a Foam Pad (30) onto each end of the Pad Tube.

30

29

34

30

28

30

34

31. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in

ADJUSTMENT, beginning on page 17 of this manual.
Before using the home gym system, pull each cable a few times to be sure that the cables move smoothly
over the pulleys. If one of the cables does not move smoothly, find and correct the problem.	IMPORTANT: If
the cables are not properly installed, they may be damaged when heavy weight is used. If there is
any slack in the cables, you will need to remove the slack by tightening the cables. See TROUBLE-
SHOOTING AND MAINTENANCE on page 18.

Cable Diagram (1)

The Cable Diagrams below and on the next page shows the proper routing of the Short Cable (58), the Butterfly
Cable (76) and the Long Cable (23). The numbers show the correct route for each Cable.	Make sure the
Cables are routed correctly, that the Pulleys move smoothly and that the Cable Traps do not touch or
bind the Cables. Incorrect cable routing can damage the weight system.

2	Short Cable (58)
4
	1
3
5
	15

Butterfly Cable (76)

4

2

5

1

3

Image 15

Contents Serial Number Decal Model No. WESY74090 Serial NoLimited Warranty Table of ContentsKeep hands and feet away from moving parts Important PrecautionsPrecautions before using the weight system Make sure the cables remain on the pulleysBefore You Begin Using the Weider Weight SystemTo make the assembly process as smooth as possi AssemblyTighten the Nylon Locknuts yet Locate and open the parts bag labeled Frame AssemblySee the inset drawing Bolts with two 5/16 Nylon LocknutsSupport Tighten all Nylon Locknuts used in steps 1 throughIs oriented as shown Locknut 3 do not tighten at this timeLocate and open the parts bag labeled ARM Make sure the welded tab on the Press FrameRight Axle with a hammer ArmCable Trap is oriented as shown Short Cable 58 is between the Pulley 15Spacer 8 x 1 Bolt 59, a 3/8 Plain Nut 56 and a 3/815b Bracket Onto the Bolt to prevent the Pulley from falling off durIng the following steps. Note Make sure the Pulley From Pulley To PulleyBolt 12 and a 3/8 Nylon Locknut 21. Note Make sure the Cable Trap is oriented as shownSpacer To the Seat 13 with two 1/4 x 3/4 Screws Shooting and Maintenance on Cable Diagram76, 87 1/2 Long CableAdjustment Cise will be reducedPin Additional slack can be removed by moving the upper Trouble-shooting and MaintenanceMake sure the Cable Trap is oriented as shown Re-install it Woven cable, the type of cable used on the home gym101 120 121 138 103 Weight Resistance ChartCables, pulleys, and weight guides LbsPart No J00885-C R0700A Ordering Replacement PartsWESY74090 R0700A Remove this Part Identification Chart from the ManualPart Identification Chart-WESY74090 Page Page Remove this Part LIST/EXPLODED Drawing from the Manual X 1/4 Spacer Qty Description Key No. Qty16 x 2 1/4 Bolt Upright X 3/4 ScrewExploded Drawing-Model No. WESY74090