Weider WESY74090 user manual Trouble-shooting and Maintenance

Trouble-shooting and Maintenance

Inspect and tighten all parts each time you use the home gym system. Replace any worn parts immediately. The home gym system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.

Tightening the Cables

Woven cable, the type of cable used on the home gym

system, can stretch slightly when it is first used. If there is slack in the Cables before resistance is felt, the Cables should be tightened.

To tighten the Cables, insert the Weight Pin (26, not shown) between the third and the fourth Weight, counting from the top. See “Changing the Weight Setting” on page 17 for instructions on moving the Weight Pin.

Tighten the 3/8” Plain Nut (56) a few turns further onto the 3/8” Eyebolt (35) and then tighten the 3/8” Nylon Jamnut

(22)securing the Eyebolt to the Leg Lever (29). Repeat this procedure until the Cables feel tighter.

Additional slack can be removed by moving the upper 3

1/2” Pulley (15) attached to the “I”-Plates (20) to the lower hole. To do this, remove the 3/8” x 2” Bolt (12), Cable Trap (66) and 3/8” Nylon Locknut (21). Move the Pulley

and re-attach it with the Bolt, Cable Trap and Locknut.

Make sure the Cable Trap is oriented as shown.

Note: If a Cable tends to slip off the Pulleys often, the Cable may have become twisted. Remove the Cable

and re-install it.

If the Cables need to be replaced, see ORDERING REPLACEMENT PARTS on the back cover of this manual.

1

29

35

22

56

1

66

21

15

20

12

18