Weider user manual Remove this Part Identification Chart from the Manual, WESY74090 R0700A

Page 21

REMOVE THIS PART IDENTIFICATION

CHART FROM THE MANUAL

This chart is provided to help you identify the small parts used in assembly. The number in
parenthesis below each part refers to the key number of the part.	Important: Some parts may

have been pre-assembled for shipping purposes. If you cannot find a part in the parts bags, check to see if it has been pre-assembled.

Note: Assembly is divided into four stages: 1) frame assembly; 2) arm assembly; 3) cable, pulley and seat assembly. The hardware for each assembly stage is packaged separately. Wait until you begin each stage to open that parts bag.

WESY74090 R0700A

Image 21

Contents Serial Number Decal Model No. WESY74090 Serial NoLimited Warranty Table of ContentsPrecautions before using the weight system Important PrecautionsMake sure the cables remain on the pulleys Keep hands and feet away from moving partsBefore You Begin Using the Weider Weight SystemTo make the assembly process as smooth as possi AssemblySee the inset drawing Locate and open the parts bag labeled Frame AssemblyBolts with two 5/16 Nylon Locknuts Tighten the Nylon Locknuts yetSupport Tighten all Nylon Locknuts used in steps 1 throughLocate and open the parts bag labeled ARM Locknut 3 do not tighten at this timeMake sure the welded tab on the Press Frame Is oriented as shownRight Axle with a hammer ArmCable Trap is oriented as shown Short Cable 58 is between the Pulley 15Spacer 8 x 1 Bolt 59, a 3/8 Plain Nut 56 and a 3/815b Ing the following steps. Note Make sure the Pulley Onto the Bolt to prevent the Pulley from falling off durFrom Pulley To Pulley BracketBolt 12 and a 3/8 Nylon Locknut 21. Note Make sure the Cable Trap is oriented as shownSpacer To the Seat 13 with two 1/4 x 3/4 Screws Shooting and Maintenance on Cable Diagram76, 87 1/2 Long CableAdjustment Cise will be reducedPin Make sure the Cable Trap is oriented as shown Re-install it Trouble-shooting and MaintenanceWoven cable, the type of cable used on the home gym Additional slack can be removed by moving the upperCables, pulleys, and weight guides Weight Resistance ChartLbs 101 120 121 138 103Part No J00885-C R0700A Ordering Replacement PartsWESY74090 R0700A Remove this Part Identification Chart from the ManualPart Identification Chart-WESY74090 Page Page Remove this Part LIST/EXPLODED Drawing from the Manual 16 x 2 1/4 Bolt Upright Qty Description Key No. QtyX 3/4 Screw X 1/4 SpacerExploded Drawing-Model No. WESY74090