9.Identify the Right Arm (48) and the Left Arm (47) by imagining yourself sitting on the seat. Note the posi-
tion of the welded bracket (A) on each Arm. | Arm | |
identification is very important for this step. |
| |
Lubricate both axles on the Press Frame (17). Slide |
| |
the Right Arm (48) onto the right axle. |
| Note: Be care- |
ful not to confuse the Right and Left Arm. Make |
| |
sure the upper end of the Right Arm is behind the | ||
indicated bracket (B) on the Press Frame. |
| |
Place two 1” Retainer Rings (69) on top of a 1” |
| |
Round Cover Cap (70) and tap all three parts onto |
| |
the Right Axle with a hammer. | Make sure the teeth | |
on the Retainer Rings bend towards the Cover Cap, as shown in the inset drawing.
Attach the Left Arm (47) in the same manner.
Press a 1 3/4” Square Inner Cap (77) into each end of the crossbar on the Press Frame (17).
10. Attach the Seat Frame (36) to the Upright (42) with
two 5/16” x 2 1/2” Bolts (14), the Support Bracket (6) and two 5/16” Nylon Locknuts (3).
11.Press a 1 1/2” Square Inner Cap (32) into the upper and lower ends of the Leg Lever (29).
Press a 1” Square Inner Cap (65) into the top of the support bracket on the Leg Lever (29).
Thread a 3/8” Plain Nut (56) partway onto the 3/8” Eyebolt (35). Insert the Eyebolt through the indicated hole in the Leg lever (29) and secure it with a 3/8” Flat Washer (9) and a 3/8” Nylon Jamnut (22).
Lubricate a 3/8” x 2” Bolt (12). Attach the Leg Lever
(29)to the bracket on the Seat Frame (36) with the Bolt and a 3/8” Nylon Jamnut (22).
9
9 |
|
|
|
|
|
| 77 |
|
| 17 | Lubricate |
|
|
| |
|
|
| 47 |
77 |
|
| B |
|
|
| 69 |
Lubricate |
|
| A |
|
| 70 | |
|
|
| 69 |
|
|
| 70 |
48 |
|
|
|
|
|
| Axle |
|
|
| 69 |
|
|
| 70 |
10 |
|
|
|
|
|
| 42 |
3 |
|
| 14 |
|
|
| |
|
|
| 36 |
| 6 |
|
|
|
|
| 14 |
11 | 36 | 22 | 65 |
| |||
|
|
| 32 |
12 Lubricate |
|
| 29 |
|
|
| |
|
| 35 | 9 |
|
|
| 56 |
|
|
| 22 |
|
|
| 32 |