Weider WESY7974.O user manual Troubleshooting, Recalibrating the Console, Tightening the Rope

Page 22

TROUBLESHOOTING

RECALIBRATING THE CONSOLE

To recalibrate the Console (21), first plug in the resist- ance system (see PLUGGING IN THE RESISTANCE

SYSTEM on page 20). Then, press and hold the NEXT button and the MOTORIZED WEIGHT

ADJUSTMENT + button for five seconds. When the buttons are released, a number will appear in the REPS display. Press the NEXT button again, and then press the MOTORIZED WEIGHT ADJUSTMENT

+button; this will start the recalibration process. This may take a few seconds as the motor moves between the lowest and highest resistance settings. When the

motor finishes, unplug the transformer from the !20- volt outlet.

The Console (21) will be recalibrated. Use the resist- ance system as described in the CONSOLE OPERA- TION section, starting on page 20.

TIGHTENING THE ROPE

The type of rope used on the resistance system can stretch slightly when it is first used. If there is slack in the rope before resistance is felt, the rope should be tightened.

To tighten the Rope (70), first set the system resist- ance level to 100 pounds. Locate the end of the Rope with the Rope Clamps (165, 166) and pull it out until the Rope is tight. Then, measure the distance between the Rope Cover (169) and the Swivel Arm (29).

Set the system resistance to the lowest level. Have a second peron pull the Rope (70) out and hold it while the Rope is adjusted. Push the Rope Cover (!69) down the Rope and loosen the two M5 x 16mm Button Screws (164). Pull the Rope through the Link (!67) and the Rope Clamps (165, 166) to shorten the Rope by the measured amount. Then, retighten the two Screws and cover the Rope Clamps with the Rope Cover. Note: There should be t/2" between the Link and the Rope Clamps.

29

70

Measure 169

Distance

164

169

70

167

166

22

Image 22
Contents Model No. WESY7974.O Serial No Service Department DirectlyQUESTIONS? Mon.-Fri., 6 a.m.-6 p.m. MSTTable of Contents Hands Clear of area Important Precautions Before YOU Begin Assembly 129 Page Make sure you do not pinch the Upper Wire Repeat this step with the other Squat Arm Page Page Page Page Page Attaching the High Pulleys AdjustmentsAttaching the LEG Lever Attaching the Curl PAD Attaching the AccessoriesAttaching the Curl BAR Adjusting the Backrest Adjusting the Squat ARMRACHING the Squat Station Adjusting the Seat Storing the Resistance SystemPlugging in the Resistance System Features of the ConsoleManual Operation Program Operation Perform the exerciseUnplug the transformer Row for five minutes to warm upRecalibrating the Console TroubleshootingTightening the Rope Exercise Guidelines Cooling Down Staying MotivatedMonday Exercise Weight Sets Reps Aerobic ExerciseAerobic Exercise Weight Sets Reps DateTuesday Page Part Identification CHART--Model No. WESY7974.0 Part LIST--Model No. WESY7974.0 R1005A Qty DescriptionKeyNo. Qty Description Qty@38 Exploded Drawing B--Model No. WESY7974.0 R1005A Exploded Drawing C--Model No. WESY7974.0 m006A Ordering Replacement Parts Limited Warranty