Whirlpool GHW9200LQ0 manual Installation Requirements, Tools and Parts, Optional Pedestal

Page 4

INSTALLATION

REQUIREMENTS

Tools and Parts

Assemble the necessary tools and supplies before beginning the washer installation. The parts supplied are in the washer drum.

Tools needed for connecting the water inlet hoses

Pliers (that open to 1⁹⁄₁₆ in. [39.5 mm])

Flashlight (optional)

Tools needed for installation

Open end wrench ⁵⁄₈ in. (17 mm) and ½ in. (13 mm)

Level

Wood block (2" x 4")

Ruler or measuring tape

Parts supplied:

Beaded strap

Transport bolt hole plug (4)

Alternate Parts

Your installation may require additional parts. If you are interested in purchasing one of the items listed here, call the toll-free number on the cover or in the "Assistance or Service" section.

If You Have

You Will Need to Buy

 

 

Laundry tub or

Sump pump system (if not already

standpipe taller

available)

than 96 in. (2.4 m)

 

 

 

Overhead sewer

Standard 20 gal. (76 L), 30 in. (76.2 cm)

 

tall drain tub or utility sink and sump

 

pump (available from local plumbing

 

suppliers)

 

 

Floor drain

Siphon break, Part Number 285834;

 

additional drain hose Part Number

 

8318155; and connector kit, Part

 

Number 285835

 

 

Drain hose too

Drain hose extension kit, Part Number

short

285863

 

 

Water faucets

2 longer water fill hoses:

beyond reach of

6 ft (1.8 m) Part Number 76314,

fill hoses

10 ft (3.0 m) Part Number 350008

 

 

Optional Pedestal

A pedestal may be purchased separately for this washer. This pedestal will add about 13 in. (33 cm) to the height of your unit for a total vertical height of approximately 51 in. (130 cm).

Optional Pedestal

To order, call the dealer from whom you purchased your washer or refer to the “Assistance or Service” section of this manual. Ask for model number LAB2700LQ.

Location Requirements

Selecting the proper location for your washer improves performance and minimizes noise and possible washer “walk.”

Your washer can be installed under a custom counter, or in a basement, laundry room, closet, or recessed area. (See “Drain System.”)

Companion appliance location requirements should also be considered. Proper installation is your responsibility.

You will need

A water heater set to deliver 120°F (49°C) water to the washer.

A grounded electrical outlet located within 5 ft (1.5 m) of where the power cord is attached to the back of the washer. (See “Electrical Requirements.”)

Hot and cold water faucets located within 4 ft (1.2 m) of the hot and cold water fill valves, and water pressure of 20-100 psi (137.9-689.6 kPa).

A level floor with a maximum slope of 1 in. (2.5 cm) under entire washer. Installing the washer on carpeting is not recommended.

A sturdy and solid floor to support the washer with a total weight (water and load) of 400 lbs (180 kg).

Do not operate your washer in temperatures below 32°F (0°C). Some water can remain in the washer and can cause damage in low temperatures.

Installation clearances

The location must be large enough to allow the washer door to be fully opened.

Additional spacing should be considered for ease of installation and servicing.

Additional clearances might be required for wall, door, and floor moldings.

Additional spacing of 1 in. (2.5 cm) on all sides of the washer is recommended to reduce noise transfer.

Companion appliance spacing should also be considered.

4

Image 4
Contents FRONT-LOADING Laveuse Automatique À Chargement FrontalUse & Care Guide Guide d’utilisation Et d’entretienTable DES Matières Washer Safety Your safety and the safety of others are very importantInstallation Requirements Tools and PartsOptional Pedestal Location RequirementsDrain System Washer DimensionsStandpipe drain system wall or floor view 1 Laundry tub drain system view Electrical RequirementsFloor drain system view Installation Instructions Remove Transport SystemConnect the Inlet Hoses Route the Drain HoseSecure the Drain Hose Complete InstallationLevel the Washer Catalyst Cleaning Action with Direct Injection Electronic ControlsSmart Dispensers Auto Water LevelWasher USE Starting Your WasherFirst Wash Cycle Without Laundry To load washerUsing the Dispenser Choosing the Right DetergentPrewash detergent compartment Main Wash detergent compartmentPausing or Restarting Status LightsCycles Options Modifiers Laundry Tips Laundry GuidePreparing clothes for washing SortingCleaning Your Washer Washer CareLoading Water Inlet HosesTroubleshooting Are you using a low speed wash cycle? Was the wash temperature too low?Did you sort properly? Did you overload the washer?If you need replacement parts For service in CanadaU.S.A CanadaWhirlpool Washer Warranty ONE-YEAR Full WarrantySecond Through Tenth Year Limited Warranty on Outer TUB Lifetime Limited Warranty on Stainless Steel Wash DrumSécurité DE LA Laveuse Votre sécurité et celle des autres est très importanteExigences ’INSTALLATION Exigences d’emplacementOutils nécessaires pour l’installation Outils et piècesDimensions de la laveuse Espacements dinstallationInstallation dans un encastrement ou placard Système de vidange Spécifications électriquesSystème de rejet à l’égout mural ou au plancher Vues 1 et Système de vidange de l’évier de buanderie VueInstructions ’INSTALLATION Enlèvement du système de transportRaccordement des tuyaux d’alimentation Connecter les tuyaux d’alimentation aux robinetsAchever l’installation Acheminement du tuyau de vidangeImmobilisation du tuyau de vidange Réglage de l’aplomb de la laveuseAvantages Utilisation DE LA Laveuse Mise en marche de la laveusePremier programme de lavage sans linge à laver Pour charger la laveuseUtilisation du distributeur Choix du détergent appropriéCompartiment pour détergent Prewash prélavage Compartiment pour détergent Main Wash lavage principalPause ou remise en marche Changement de programmes, options et ModificateursCompartiment d’eau de Javel Compartiment d’assouplissant de tissuTémoins lumineux ProgrammesNormal/Casual Normal/Tout-aller Quick Wash Lavage rapideDelicate Tissus délicats Silk SoieSons normaux émis par la laveuse Prewash PrélavageAuto Soak Trempage automatique Extra Rinse Rinçage supplémentaireWash/Rinse Temp Température de lavage/rinçage Guide de températureTempérature de l’eau de Tissus suggérés Lavage HOT Chaude Warm TièdeGuide de lessivage Programme Type DE Charge Suggéré Options DisponiblesAuto Soak Extra Rinse Rinse Hold Rinçage Auto Supplémen Attente MatiqueConseils DE Lessivage ChargementEntretien DE LA Laveuse Nettoyage de la laveuseDépannage Avez-vous surchargé la laveuse? Avez vous effectué le tri correctement?Avez-vous utilisé suffisamment de détergent? Avez-vous bien trié la charge? Avez-vous déchargé la laveuse promptement?La température de lavage est-elle trop basse? La charge a-t-elle provoqué un déséquilibre?Pour le service au Canada Aux États-UnisAu Canada Si vous avez besoin de pièces de rechangeGarantie Complète DE UN AN Garantie DE LA Laveuse WhirlpoolWhirlpool Corporation ne paiera pas pour 4619 7020 Whirlpool Corporation All rights reserved