Whirlpool GHW9200LQ0 Installation Instructions, Remove Transport System, Connect the Inlet Hoses

Page 7

INSTALLATION

INSTRUCTIONS

Remove Transport System

WARNING

Excessive Weight Hazard

Use two or more people to move and install washer.

Failure to do so can result in back or other injury.

IMPORTANT: Position the washer so that the rear of the unit is within approximately 3 ft (90 cm) of the final location.

There are 4 bolts in the rear panel of the washer that support the suspension system during transportation.

HOTCOLD

1.Using a ½ in. (13 mm) wrench, loosen each of the bolts.

2.Once the bolt is loose, move it to the center of the hole and completely pull out the bolt, including the plastic spacer covering the bolt and the cable attached to the bolt. The power cord will be attached to all 4 bolts.

3.Once all 4 bolts are removed, remove the power cord from each bolt holder, and discard bolts, plastic spacers, and cables.

4.Close the holes with the transport bolt hole plugs.

Connect the Inlet Hoses

Connect the inlet hoses to the water faucets

Make sure the washer drum is empty.

1.Using pliers, check the tightness of the hose couplings already attached to the washer.

NOTE: Do not overtighten. Damage to the coupling can result.

2.Attach the hose with the red color indicator to the hot water faucet. Screw on coupling by hand until it is seated on the washer.

3.Attach the hose with the blue color indicator to the cold water faucet. Screw on coupling by hand until it is seated on the washer.

4.Using pliers, tighten the couplings with an additional two- thirds turn.

NOTE: Do not overtighten. Damage to the coupling can result.

5.Turn on the water faucets and check for leaks.

NOTE: Replace inlet hoses after 5 years of use to reduce the risk of hose failure. Record hose installation or replacement dates on the hoses for future reference.

Periodically inspect and replace hoses if bulges, kinks, cuts, wear, or leaks are found.

Route the Drain Hose

Proper routing of the drain hose protects your floors from damage due to water leakage. Carefully read and follow these instructions.

The drain hose is connected to your washer.

To prevent drain water from going back into the washer:

Do not straighten the drain hose, and do not force excess drain hose into standpipe. Hose should be secure, but loose enough to provide a gap for air.

Do not lay excess hose on the bottom of the laundry tub.

Floor drain

You may need additional parts. (See Floor Drain under “Alternate Parts.”)

7

Image 7
Contents Guide d’utilisation Et d’entretien FRONT-LOADINGLaveuse Automatique À Chargement Frontal Use & Care GuideTable DES Matières Your safety and the safety of others are very important Washer SafetyLocation Requirements Installation RequirementsTools and Parts Optional PedestalDrain System Washer DimensionsStandpipe drain system wall or floor view 1 Laundry tub drain system view Electrical RequirementsFloor drain system view Route the Drain Hose Installation InstructionsRemove Transport System Connect the Inlet HosesSecure the Drain Hose Complete InstallationLevel the Washer Auto Water Level Catalyst Cleaning Action with Direct InjectionElectronic Controls Smart DispensersTo load washer Washer USEStarting Your Washer First Wash Cycle Without LaundryMain Wash detergent compartment Using the DispenserChoosing the Right Detergent Prewash detergent compartmentStatus Lights Pausing or RestartingCycles Options Modifiers Sorting Laundry TipsLaundry Guide Preparing clothes for washingWater Inlet Hoses Cleaning Your WasherWasher Care LoadingTroubleshooting Did you overload the washer? Are you using a low speed wash cycle?Was the wash temperature too low? Did you sort properly?Canada If you need replacement partsFor service in Canada U.S.ALifetime Limited Warranty on Stainless Steel Wash Drum Whirlpool Washer WarrantyONE-YEAR Full Warranty Second Through Tenth Year Limited Warranty on Outer TUBVotre sécurité et celle des autres est très importante Sécurité DE LA LaveuseOutils et pièces Exigences ’INSTALLATIONExigences d’emplacement Outils nécessaires pour l’installationDimensions de la laveuse Espacements dinstallationInstallation dans un encastrement ou placard Système de vidange de l’évier de buanderie Vue Système de vidangeSpécifications électriques Système de rejet à l’égout mural ou au plancher Vues 1 etConnecter les tuyaux d’alimentation aux robinets Instructions ’INSTALLATIONEnlèvement du système de transport Raccordement des tuyaux d’alimentationRéglage de l’aplomb de la laveuse Achever l’installationAcheminement du tuyau de vidange Immobilisation du tuyau de vidangeAvantages Pour charger la laveuse Utilisation DE LA LaveuseMise en marche de la laveuse Premier programme de lavage sans linge à laverCompartiment pour détergent Main Wash lavage principal Utilisation du distributeurChoix du détergent approprié Compartiment pour détergent Prewash prélavageCompartiment d’assouplissant de tissu Pause ou remise en marcheChangement de programmes, options et Modificateurs Compartiment d’eau de JavelProgrammes Témoins lumineuxSilk Soie Normal/Casual Normal/Tout-allerQuick Wash Lavage rapide Delicate Tissus délicatsExtra Rinse Rinçage supplémentaire Sons normaux émis par la laveusePrewash Prélavage Auto Soak Trempage automatiqueWarm Tiède Wash/Rinse Temp Température de lavage/rinçageGuide de température Température de l’eau de Tissus suggérés Lavage HOT ChaudeRinçage Auto Supplémen Attente Matique Guide de lessivageProgramme Type DE Charge Suggéré Options Disponibles Auto Soak Extra Rinse Rinse HoldChargement Conseils DE LessivageNettoyage de la laveuse Entretien DE LA LaveuseDépannage Avez-vous surchargé la laveuse? Avez vous effectué le tri correctement?Avez-vous utilisé suffisamment de détergent? La charge a-t-elle provoqué un déséquilibre? Avez-vous bien trié la charge?Avez-vous déchargé la laveuse promptement? La température de lavage est-elle trop basse?Si vous avez besoin de pièces de rechange Pour le service au CanadaAux États-Unis Au CanadaGarantie Complète DE UN AN Garantie DE LA Laveuse WhirlpoolWhirlpool Corporation ne paiera pas pour Whirlpool Corporation All rights reserved 4619 7020