Whirlpool MED9600SQ0 manual Dryer Care

Page 24

DRYER CARE

Cleaning the Dryer Location

Keep dryer area clear and free from items that would obstruct the flow of combustion and ventilation air.

WARNING

Explosion Hazard

Keep flammable materials and vapors, such as gasoline, away from dryer.

Place dryer at least 18 inches (46 cm) above the floor for a garage installation.

Failure to do so can result in death, explosion, or fire.

Cleaning the Lint Screen

Every load cleaning

The lint screen is located in the door opening of the dryer. A screen blocked by lint can increase drying time.

To clean

1.Pull the lint screen straight up. Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is hard to remove.

3.Wet a nylon brush with hot water and liquid detergent. Scrub lint screen with the brush to remove residue buildup.

4.Rinse screen with hot water.

5.Thoroughly dry lint screen with a clean towel. Replace screen in dryer.

Cleaning the Dryer Interior

To clean dryer drum

1.Make a paste with powdered laundry detergent and very warm water.

2.Apply paste to a soft cloth.

OR

Apply a liquid, nonflammable household cleaner to the stained area and rub with a soft cloth until all excess dye and stains are removed.

3.Wipe drum thoroughly with a damp cloth.

4.Tumble a load of clean cloths or towels to dry drum.

NOTE: Garments that contain unstable dyes, such as denim blue jeans or brightly colored cotton items, may discolor the dryer interior. These stains are not harmful to your dryer and will not stain future loads of clothes. Dry unstable dye items inside out to avoid dye transfer.

2.Push the lint screen firmly back into place.

IMPORTANT:

Do not run the dryer with the lint screen loose, damaged, blocked, or missing. Doing so can cause overheating and damage to both the dryer and fabrics.

If lint falls off the screen into the dryer during removal, check the exhaust hood and remove the lint. See “Venting Requirements.”

As needed cleaning

Laundry detergent and fabric softener residue can build up on the lint screen. This buildup can cause longer drying times for your clothes, or cause the dryer to stop before your load is completely dry. The screen is probably clogged if lint falls off while the screen is in the dryer.

Clean the lint screen with a nylon brush every 6 months, or more frequently, if it becomes clogged due to a residue buildup.

To wash

1.Roll lint off the screen with your fingers.

2.Wet both sides of lint screen with hot water.

Removing Accumulated Lint

From Inside the Dryer Cabinet

Lint should be removed every 2 years, or more often, depending on dryer usage. Cleaning should be done by a qualified person.

From the Exhaust Vent

Lint should be removed every 2 years, or more often, depending on dryer usage.

Vacation andMovingCare

Vacation care

Operate your dryer only when you are at home. If you will be on vacation or not using your dryer for an extended period of time, you should:

1.Unplug dryer or disconnect power.

2.Clean lint screen. See “Cleaning the Lint Screen.”

Moving care

For power supply cord-connected dryers:

1.Unplug the power supply cord.

2.Make sure leveling legs are secure in dryer base.

3.Use masking tape to secure dryer door.

24

Image 24
Contents Table of Contents/Índice/Table des matières W10099070ATable of Contents Table DES MatièresDryer Safety Your safety and the safety of others are very importantInstallation Instructions Toolsand PartsOptions Installation clearances Dryer DimensionsCustom undercounter installation Dryer only Location RequirementsRecommended installation spacing for cabinet InstallationMobile home Additional installation requirements Mobile home installations requireElectricalRequirements- U.S.A. Only It is your responsibilityElectrical Requirements -Canada Only At least 5 ft 1.52 m longFor a grounded, cord-connected dryer Power Supply Cord Direct Wire Install strain reliefStyle 1 Power supply cord strain relief Electrical Connection -U.S.A.OnlyWire connection Power supply cord Style 2 Direct wire strain reliefWire connection Direct wire BDE CG F Optional 3-wire connection If using an existing vent system Venting RequirementsIf this is a new vent system Vent material Optional exhaust installations Alternate installations for close clearancesPlanVent System Angled hood style shown here is acceptableInstallVent System InstallLeveling LegsVent system chart Special provisions for mobile home installationsLevel Dryer Connect VentReverse DoorSwing Remove the doorComplete Installation Reinstalling the doorDryer USE Starting Your DryerTo use an Automatic Cycle PausingorRestarting Stopping Your DryerControl Locked Drying and Cycle TipsStatusLights CyclesAdditional Features Cycle End Signal DryingRackDryer Care Troubleshooting Changing theDrumLightDryerOperation Dryer Results Assistance or Service If you need replacement partsTheU.S.A For further assistanceMaytag Corporation Major Appliance Warranty Seguridad DE LA Secadora Su seguridad y la seguridad de los demás es muy importanteInstrucciones DE Instalación Herramientas ypiezasOpciones RequisitosdeubicaciónDimensiones de la secadora Espacios para la instalaciónEspacio necesario Instalación en un clóset Sólo para la secadoraRequisitoseléctricos- Sólo en EE.UU Las instalaciones en casas rodantes necesitanUsted es responsable de Conexión eléctricaSi emplea un cable de suministro eléctrico Si el contacto de pared luce como ésteConexión eléctrica- Sólo enEE.UU Cable de suministro eléctricoCable directo Instale el protector de cablesConexión de 4 hilos Cable de suministro eléctrico Estilo 2 Protector de cables para cable directoAlambre de 4 hilos se recomienda Alambre de 3 hilos si no dispone de alambre de 4 hilosConexión de 4 hilos Cable directo Tornillo conductor de tierra externoConexión de 3 hilos Cable de suministro eléctrico Conexión de 3 hilos Cable directoConexión opcional de 3 hilos Requisitos deventilación Si usa un sistema de ventilación existenteSi éste es un nuevo sistema de ventilación Planificación delsistema deventilación Instalaciones opcionales de escapeInstalaciones alternas para espacios limitados Instalación delsistema deventilación Instalacióndelas patas niveladorasDeterminación de la vía del ducto de escape Cuadro del sistema de ventilaciónCómo invertirelcierre de la puerta Nivelación de la secadoraConexión del ducto de escape Cómo quitar la puertaCómo invertir la bisagra y el soporte de la bisagra Cómo volver a instalar la puertaEstilo 1 Quite la cinta de tapón Estilo 2 Quite la etiquetaCompletela instalación EE.UU Lea Uso de la secadoraSi la secadora no funciona, revise lo siguiente USO DE LA Secadora Puesta enmarchade la secadoraPara usar un ciclo Automático Dirija el selector hacia un ciclo AutomáticoDetención de lamarcha Delasecadora Pausa o reanudación dela marchaControl bloqueado Sugerencias deciclos ysecadoLuces deestado CiclosCaracterísticasadicionales Señal de Fin de Ciclo Cycle End Signal EstantedesecadoSólo aire Air Only Cuando use Sólo aireCuidado DE LA Secadora Limpiezadellugardonde estálasecadoraLimpieza del filtro depelusa Limpieza de cada cargaLimpieza del interiordela secadora Eliminación depelusa acumuladaCuidado para las vacaciones y la mudanza Cambiodela luzdel tamborSolución DE Problemas Funcionamiento dela secadoraResultadosdela secadora El tiempo del ciclo es demasiado corto Pelusa en la ropaManchas en la carga o en el tambor Ropa arrugadaAyuda O Servicio Técnico Si necesita piezas de repuestoNuestros consultores ofrecen asistencia con respecto a Para obtener más asistenciaDE Maytag Corporation EE.UU., llame al 1-800-688-9900. En Canadá, llame alSécurité DE LA Sécheuse Votre sécurité et celle des autres est très importanteInstructions Dinstallation Exigences demplacementOutillageetpièces Dimensions de la sécheuse Installation dans un placard Sécheuse seulementDégagements de séparation à respecter Espacement requisEspacement recommandé pour linstallation dans un placard Linstallation dans une maison mobile exigeSpécificationsélectriques ’est à l’utilisateur qu’incombe la responsabilité deExigencesconcernantlévacuation En cas dutilisation du système dévacuation existantConduit métallique rigide Conduit métallique flexibleInstallations d’évacuation facultatives Planification du systèmed’évacuationBrides de serrage ÉvacuationAutres installations où le dégagement est réduit Déterminer litinéraire dacheminement du conduitTableau des systèmes dévacuation Une réduction de la longévité de la sécheuseInstallation dusystème d’évacuation Installation despiedsdenivellementMise à niveau dela sécheuse Raccordement du conduitd’évacuationRéinstallation de la porte Inverser la charnière et son supportAcheverl’installation Style 2 Retirer l’étiquetteSi la sécheuse ne démarre pas, vérifier ce qui suit Fermer la porte et vérifier qu’elle s’enclenche solidementUtilisation DE LA Sécheuse Miseen marchedela sécheuseUtilisation dun programme automatique Verrouillage descommandes Arrêt de la sécheusePauseou remiseen marche Conseilspourle séchage et lesprogrammesTémoins lumineux ProgrammesCaractéristiques supplémentaires Cycle End Signal signal de fin de programme Grille deséchageAir Only air seulement Utilisation du réglage Air OnlyNettoyage de lemplacement de La sécheuse Entretien DE LA SécheuseNettoyage du filtreàcharpie Nettoyage del’intérieur de lasécheuseDépannage Retraitdela charpie accumuléeChangementdel’ampoule d’éclairage Dutambour Fonctionnement de la sécheuseRésultats de la sécheuse La sécheuse affiche un message codéTemps de programme trop court Assistance OU Service Au CanadaGarantie DES Gros Appareils Ménagers Maytag Corporation Garantie Limitée DE UN ANW10099070A Todos los derechos reservados