JVC LVT1306-007A manual Connecting the speakers, Speaker Layout Diagram

Connecting the speakers

Do not connect the AC power plug to the wall outlet until all connections are completed.

Speaker Layout Diagram

C

L R SW

LS RS

				CAUTION:SPEAKER
				IMPEDANCE 6		– 16
FRONT		CENTER	SURROUND
RIGHT	LEFT		RIGHT	LEFT	SPEAKERS

Powered subwoofer (SW)

SUBWOOFER

OUT

Right front speaker
(R)
Left front speaker		Left surround
		speaker (LS)
(L)
		Right surround
	Center speaker (C)
		speaker (RS)

Connecting the speakers

Turn off all components before making connections.

Connecting the powered subwoofer

By connecting a subwoofer, you can enhance the bass or reproduce the original LFE signals recorded in digital software.

1	2	3
	2	1

1Twist and remove the insulation at the end of each speaker cord.

2Press and hold the clamp of the speaker terminal (1), then insert the speaker cord (2).

•For each speaker, connect the (+) and (–) terminals on the rear panel to the (+) and (–) terminals marked on the speakers.

3Release the finger from the clamp.

CAUTIONS:

•Use speakers with the SPEAKER IMPEDANCE indicated by the speaker terminals (6 Ω – 16 Ω).

•DO NOT connect more than one speaker to one speaker terminal.

Connect the input jack of a powered subwoofer to the SUBWOOFER OUT jack on the rear panel, using a cord with RCA pin plugs (not supplied).

• Refer also to the manual supplied with your subwoofer.

After connecting all the speakers and/or a subwoofer, set the speaker setting information properly to obtain the best possible surround effect. For details, see pages 16, 17, and 21 to 23.

NOTE

You can place a subwoofer wherever you like since bass sound is non-directional. Normally place it in front of you.

6