Installation
Installation surface
A concrete floor is the most suitable in- stallation surface for a washing ma- chine, being far less prone to vibration during the spin cycle than wooden floorboards or a carpeted surface.
Please note the following points:
^The machine must be level and se- curely positioned.
^To avoid vibrations during spinning, the machine should not be installed on soft floor coverings.
^If installing on a wooden joist floor, we recommend a plywood base (at least 60x45x3 cm). The base should span several joists and be bolted to the joists and not only to the floorboards. Check for the presence of pipes and cables first.
^If possible, install the machine in a corner, as this is usually the most sta- ble part of the floor.
Levelling and adjusting
Lift the appliance from its packaging base and move it to its installation site.
Please note:
^Ensure that the machine feet and the floor are dry to prevent the machine from slipping during the spin cycle.
^Remove the transit fitting (next page).
The appliance must be level to ensure safe and proper operation.
^Unscrew the feet until the machine stands level.
^Hold the foot tight using a pipe wrench.
^Tighten the counternut using a screwdriver as indicated.
53