Miele T 4262 C How to dry correctly, Brief instructions, Sort the laundry, Load the tumble dryer

Page 11

How to dry correctly

Brief instructions

The headings numbered (A, B, C ...) show the operating sequence and can be used as a brief guide to using your machine.

A Sort the laundry

To ensure an even drying result separate out the washed laundry and sort it according to: . .

. . . the drying level required

. . . the type of fibre or weave

. . size

. . the moisture content after spinning.

,Make sure that objects e.g. detergent dispensing balls have been removed from the laundry. They could melt, and cause damage to the dryer or the laundry.

Check seams and stitching to ensure that padding and linings are intact.

Fasten duvet covers and pillow cases to prevent small items from being trapped inside them.

Fasten hooks and eyes etc.

Tie fabric belts and apron strings.

Sew in or remove underwiring from bras.

B Turn on the tumble dryer

^Switch the dryer on by pressing the I-On/0-Offbutton in.

The tumble dryer may be switched on after loading, saving energy as the light will not come on.

C Load the tumble dryer

^Press the Door button to open the door.

^Load the laundry loosely into the drum.

Do not overload the drum. See the "Programme chart" for recommended loads for each programme.

Overloading can cause unnecessary wear and tear to the laundry and give a disappointing drying result.

^Before closing the door make sure the fluff filter is correctly positioned.

Check the laundry is right inside the drum so that it cannot get trapped or damaged when the door is shut.

^Shut the door either with a gentle swing, or lean against it and push it shut.

11

Image 11
Contents Operating instructions For condenser tumble dryer T 4262 C Energy saving tips Caring for the environmentDisposal of the packing material Disposal of your old applianceContents Consumption data Technical data Correct use Technical safetyPage Operation Disposal of your old machine Safety with childrenUsing accessories Programme sequence and check lamps PC indicator lightControl panel Programme selectorTips on drying Care symbolsTurn on the tumble dryer How to dry correctlyBrief instructions Sort the laundryStart the programme Low temperatureSelect a programme Changing the programme sequence Programme chart Cool air AutomaticTimed drying Warm airEmptying the condensed water container Cleaning and careCleaning them whilst dry Cleaning the fluff filtersCleaning them with water Cleaning the tumble dryerRemoving the condenser unit Cleaning the condenser unitChecking the condenser unit Replacing the condenser unit General problems Problem solving guideNot sufficiently Problem Possible cause Remedy There is a buildUp of fluff Laundry isGoes on too long or Problem Possible cause Remedy Drying processEven switches off Check and fault indicator lamps Sequence display Problem Possible cause Remedy Programme hasStopped, Has come onChanging the lamp Repairs After sales serviceAppliance guarantee Optional accessoriesFront view InstallationReplacing the lid Installation siteTransporting the machine to its installation site Washer dryer stack Before moving the machine again e.g. when moving houseLevelling the machine Room in which the dryer is locatedExternal condensed water outlet Setting up the drain hoseConnection to a sink drain outlet Electrical connection U.K Non-rewireable plugs BSElectrical connection Smoothing Consumption dataTechnical data Programmable functions for changing standard settings To check Programmable functionsProgrammable functions Buzzer is activated Activating and deactivating the buzzerBuzzer is deactivated Cooling down time is not extended Extending the cooling down timeCooling down time will be five miinutes longer Cooling down time will be ten minutes longerStandard drying level is Normal+ Standard drying level is Hand iron Alteration rights reserved/0505