Miele T 4262 C operating instructions Standard drying level is Hand iron

Page 43

Programmable functions

Changing the standard drying level in the Automatic programme

The drying level for this programme is set at a standard level.

You have the option of changing this to an increased drying level.

The machine is delivered with the drying level set at Normal

You can change this to Hand iron (damper) or Normal+ (drier than the standard drying level).

Follow steps A to G to programme and store in memory.

Before you begin, first ensure that:

The tumble dryer is switched off.

The door is closed.

The programme selector is at Finish.

APress the Start button and keep it pressed in whilst carrying out steps

B-C.

BSwitch the dryer on with the I-On/0-Offbutton.

CWait until the Start indicator lamp comes on . . .

D. . . and then release the Start button.

ETurn the programme selector to the Automatic position.

FPressing the Start button alters the drying level.

If the Drying indicator lamp flashes twice:

the standard drying level is Normal+

If the Drying indicator lamp is not flashing:

the standard drying level is Hand iron

If the Drying indicator lamp flashes once, the drying level has not been changed and will remain on the stan-

dard setting ().

GSwitch the machine off with the I-On/0-Offbutton.

The setting you have selected is now stored in memory. You can change it again at any time.

To check:

^Make sure the dryer is switched off, the door is closed and the programme selector is at Finish and then carry out steps A to E.

The Drying indicator lamp will show you if the drying level has been changed.

^Switch off the dryer. The check is complete.

43

Image 43
Contents Operating instructions For condenser tumble dryer T 4262 C Energy saving tips Caring for the environmentDisposal of the packing material Disposal of your old applianceContents Consumption data Technical data Correct use Technical safetyPage Operation Using accessories Safety with childrenDisposal of your old machine Programme sequence and check lamps PC indicator lightControl panel Programme selectorTips on drying Care symbolsTurn on the tumble dryer How to dry correctlyBrief instructions Sort the laundrySelect a programme Low temperatureStart the programme Changing the programme sequence Programme chart Cool air AutomaticTimed drying Warm airEmptying the condensed water container Cleaning and careCleaning them whilst dry Cleaning the fluff filtersCleaning them with water Cleaning the tumble dryerRemoving the condenser unit Cleaning the condenser unitChecking the condenser unit Replacing the condenser unit General problems Problem solving guideNot sufficiently Problem Possible cause Remedy There is a buildUp of fluff Laundry isEven switches off Problem Possible cause Remedy Drying processGoes on too long or Check and fault indicator lamps Sequence display Problem Possible cause Remedy Programme hasStopped, Has come onChanging the lamp Repairs After sales serviceAppliance guarantee Optional accessoriesFront view InstallationTransporting the machine to its installation site Installation siteReplacing the lid Washer dryer stack Before moving the machine again e.g. when moving houseLevelling the machine Room in which the dryer is locatedExternal condensed water outlet Setting up the drain hoseConnection to a sink drain outlet Electrical connection Non-rewireable plugs BSElectrical connection U.K Smoothing Consumption dataTechnical data Programmable functions for changing standard settings To check Programmable functionsProgrammable functions Buzzer is deactivated Activating and deactivating the buzzerBuzzer is activated Cooling down time is not extended Extending the cooling down timeCooling down time will be five miinutes longer Cooling down time will be ten minutes longerStandard drying level is Normal+ Standard drying level is Hand iron Alteration rights reserved/0505