Miele T 4262 C Installation site, Transporting the machine to its installation site

Page 30

Installation

Installation site

,Make sure the dryer door can be opened without hindrance after installation.

Transporting the machine to its installation site

When moving the machine you can hold it by the lid where it protrudes to the rear of the dryer.

To manoeuvre the dryer out of its packing case to its installation site you will also need to hold it by the front feet.

Building under a continous worktop / in a row of kitchen units

The dryer should not be installed next to a refrigerator or freezer. The warm air expelled from the rear of the dryer would increase the temperature around the refrigerator's/freezer's heat exchanger causing the compressor to run continuously.

If it is not possible to install the dryer anywhere else, then the refrigerator/freezer must be sealed off from the dryer.

If you wish to push your machine under a worktop and there is space to do this without removing the lid, a building under kit is not necessary. Otherwise the building under kit is essential.

,The building under kit* must be fitted by a suitably qualified person. The machine lid is replaced by a coverplate. It is essential that the coverplate is fitted to ensure electrical safety.

The building under kit is supplied with its own installation instructions.

N.B. When built under running times may be longer.

The electrical socket must be located in an accessible position near the machine.

With niche heights of:

840 mm, longer screw feet* are required.

870/885 mm - 915/930 mm, one or two height adjustment frames* are required.

*Available as an optional accessory from your Miele dealer or the Miele Spare Parts Department.

Replacing the lid

If the lid has been removed in order to fit a cover plate, ensure that, if the lid is replaced, it fits securely into the rear holders. Otherwise, it is not properly secure for transport.

30

Image 30
Contents Operating instructions For condenser tumble dryer T 4262 C Disposal of your old appliance Caring for the environmentDisposal of the packing material Energy saving tipsContents Consumption data Technical data Technical safety Correct usePage Operation Safety with children Using accessoriesDisposal of your old machine Programme selector PC indicator lightControl panel Programme sequence and check lampsCare symbols Tips on dryingSort the laundry How to dry correctlyBrief instructions Turn on the tumble dryerLow temperature Select a programmeStart the programme Changing the programme sequence Programme chart Warm air AutomaticTimed drying Cool airCleaning and care Emptying the condensed water containerCleaning the fluff filters Cleaning them whilst dryCleaning the tumble dryer Cleaning them with waterCleaning the condenser unit Removing the condenser unitChecking the condenser unit Replacing the condenser unit Problem solving guide General problemsLaundry is Problem Possible cause Remedy There is a buildUp of fluff Not sufficientlyProblem Possible cause Remedy Drying process Even switches offGoes on too long or Check and fault indicator lamps Has come on Problem Possible cause Remedy Programme hasStopped, Sequence displayChanging the lamp Optional accessories After sales serviceAppliance guarantee RepairsInstallation Front viewInstallation site Transporting the machine to its installation siteReplacing the lid Room in which the dryer is located Before moving the machine again e.g. when moving houseLevelling the machine Washer dryer stackSetting up the drain hose External condensed water outletConnection to a sink drain outlet Non-rewireable plugs BS Electrical connectionElectrical connection U.K Consumption data SmoothingTechnical data Programmable functions for changing standard settings Programmable functions To checkProgrammable functions Activating and deactivating the buzzer Buzzer is deactivatedBuzzer is activated Cooling down time will be ten minutes longer Extending the cooling down timeCooling down time will be five miinutes longer Cooling down time is not extendedStandard drying level is Normal+ Standard drying level is Hand iron Alteration rights reserved/0505