Miele T 4262 C operating instructions Cleaning the fluff filters, Cleaning them whilst dry

Page 17

Cleaning and care

Cleaning the fluff filters

The fluff which is created by the drying process is collected by the fluff filters in the door and the door opening. Clean the filters after each drying programme.

^Remove any fluff from the hollow part of the door holder. A cleaning brush is available as an optional extra from your Miele dealer or the Miele Spare Parts Department.

 

Tip: You can also use a vacuum

Cleaning them whilst dry

cleaner.

 

^ Once clean, push the filter back into

 

the door holder until it clicks into

 

position. Ensure it is facing the

 

correct way.

 

^ Also clean the door seal (2) with a

 

damp cloth.

^ Open the door and pull the fluff filter

(1) out of the door as illustrated.

^ Use your fingers to remove the fluff from the two fluff filters in the door opening.

^ Close the door.

^Use your fingers to remove the fluff from the surface of the filter.

17

Image 17
Contents Operating instructions For condenser tumble dryer T 4262 C Disposal of the packing material Caring for the environmentDisposal of your old appliance Energy saving tipsContents Consumption data Technical data Correct use Technical safetyPage Operation Disposal of your old machine Safety with childrenUsing accessories Control panel PC indicator lightProgramme selector Programme sequence and check lampsTips on drying Care symbolsBrief instructions How to dry correctlySort the laundry Turn on the tumble dryerStart the programme Low temperatureSelect a programme Changing the programme sequence Programme chart Timed drying AutomaticWarm air Cool airEmptying the condensed water container Cleaning and careCleaning them whilst dry Cleaning the fluff filtersCleaning them with water Cleaning the tumble dryerRemoving the condenser unit Cleaning the condenser unitChecking the condenser unit Replacing the condenser unit General problems Problem solving guideUp of fluff Problem Possible cause Remedy There is a buildLaundry is Not sufficientlyGoes on too long or Problem Possible cause Remedy Drying processEven switches off Check and fault indicator lamps Stopped, Problem Possible cause Remedy Programme hasHas come on Sequence displayChanging the lamp Appliance guarantee After sales serviceOptional accessories RepairsFront view InstallationReplacing the lid Installation siteTransporting the machine to its installation site Levelling the machine Before moving the machine again e.g. when moving houseRoom in which the dryer is located Washer dryer stackExternal condensed water outlet Setting up the drain hoseConnection to a sink drain outlet Electrical connection U.K Non-rewireable plugs BSElectrical connection Smoothing Consumption dataTechnical data Programmable functions for changing standard settings To check Programmable functionsProgrammable functions Buzzer is activated Activating and deactivating the buzzerBuzzer is deactivated Cooling down time will be five miinutes longer Extending the cooling down timeCooling down time will be ten minutes longer Cooling down time is not extendedStandard drying level is Normal+ Standard drying level is Hand iron Alteration rights reserved/0505