Installation
Connection to a sink drain outlet
The drain hose can be connected directly to a sink drain outlet.
^Remove the following from the back of the dryer at the bottom:
Adapter 1 and hose clip 3 behind it.
^Fit adapter 1 to the sink drain outlet using nut 2.
If this nut has a flat disc in it you should take the disc out first. Important: if this nut has a washer or seal in it this must not be removed!
^Attach the end of the hose to adapter 1.
^Use a screwdriver to tighten hose clip 3 up close to the nut.
If you no longer wish to use an external condensed water outlet
,Do not push the drain hose back into the dryer. Doing this could cause it to become kinked and damaged in the dryer.
^Loop the drain hose up.
^Use a suitable cable tie to secure the looped hose to the back of the dryer, or simply lay the looped hose behind the dryer.
^Attach the open end of the drain hose back onto the holder at the back of the dryer at the top (see holder 2 in "Pulling out the drain hose").
33