Miele T 4262 C operating instructions Cleaning and care, Emptying the condensed water container

Page 16

Cleaning and care

Emptying the condensed water container

The condensed water will be collected in the condensed water container unless the machine has been fitted with a drain hose (see installation).

The condensed water container should be emptied after every drying cycle or as soon as the Empty out container indicator lamp comes on.

The drying programme will be interrupted if the maximum level of the condensed water container is reached. The Empty out container indicator lamp comes on and the buzzer sounds.

^Grip the container firmly with both hands, as shown, and pull it out slightly towards the right-hand side.

^Hold the container with both hands and carry it in a horizontal position.

^Open the shutter and empty out the water.

^To replace the container hold it at a slight angle (as when removing it) and push it in gently until you feel it click into position.

^Before starting a new programme, first switch the machine off and then on again. The Empty out container indicator lamp will go out.

Condensed water should not be consumed. It could lead to health problems for people and animals.

Condensed water can be put to household use (e.g. used in a steam iron or humidifier). To ensure that any residual particles of fluff in the condensed water are removed before use, pass it through a fine sieve or paper filter first.

16

Image 16
Contents Operating instructions For condenser tumble dryer T 4262 C Caring for the environment Disposal of the packing materialDisposal of your old appliance Energy saving tipsContents Consumption data Technical data Technical safety Correct usePage Operation Using accessories Safety with childrenDisposal of your old machine PC indicator light Control panelProgramme selector Programme sequence and check lampsCare symbols Tips on dryingHow to dry correctly Brief instructionsSort the laundry Turn on the tumble dryerSelect a programme Low temperatureStart the programme Changing the programme sequence Programme chart Automatic Timed dryingWarm air Cool airCleaning and care Emptying the condensed water containerCleaning the fluff filters Cleaning them whilst dryCleaning the tumble dryer Cleaning them with waterCleaning the condenser unit Removing the condenser unitChecking the condenser unit Replacing the condenser unit Problem solving guide General problemsProblem Possible cause Remedy There is a build Up of fluffLaundry is Not sufficientlyEven switches off Problem Possible cause Remedy Drying processGoes on too long or Check and fault indicator lamps Problem Possible cause Remedy Programme has Stopped,Has come on Sequence displayChanging the lamp After sales service Appliance guaranteeOptional accessories RepairsInstallation Front viewTransporting the machine to its installation site Installation siteReplacing the lid Before moving the machine again e.g. when moving house Levelling the machineRoom in which the dryer is located Washer dryer stackSetting up the drain hose External condensed water outletConnection to a sink drain outlet Electrical connection Non-rewireable plugs BSElectrical connection U.K Consumption data SmoothingTechnical data Programmable functions for changing standard settings Programmable functions To checkProgrammable functions Buzzer is deactivated Activating and deactivating the buzzerBuzzer is activated Extending the cooling down time Cooling down time will be five miinutes longerCooling down time will be ten minutes longer Cooling down time is not extendedStandard drying level is Normal+ Standard drying level is Hand iron Alteration rights reserved/0505