Miele T 4262 C operating instructions Changing the programme sequence

Page 13

How to dry correctly

F Remove the laundry

^Press the Door button.

^Open the door.

^Remove the laundry.

Make sure that the drum is empty. If items are left in the dryer, they could be damaged by overdrying when the dryer is next used.

^Switch the dryer off by pressing the l-On/0-Offbutton.

^Clean the fluff filters.

^Close the door.

^Empty the condensed water container (where there is no external drainage of the water).

^The condenser unit should be checked and cleaned on a regular basis.

Changing the programme sequence

Changing a programme while it is running

As long as the cooling down phase or the anti-crease phase has not been reached, it is possible to change a programme after it has started by turning the programme selector to a different programme position.

To interrupt a programme

^Switch the machine off with the I-On/0-Offbutton.

To continue drying:

^Switch the dryer on with the I-On/0-Offbutton.

The programme will continue (only with the Cottons, Minimum iron and Auto- matic programmes).

Other programmes:

^Press the Start button.

To cancel a programme

^Turn the programme selector to Finish or open the door.

Adding or removing laundry after a programme has started

^Press the Door button.

^Open the door.

,Do not touch the back of the drum when adding or removing items. The drum could be very hot - danger of burning.

^Add or remove items.

^Close the door.

^Press the Start button.

13

Image 13
Contents Operating instructions For condenser tumble dryer T 4262 C Disposal of the packing material Caring for the environmentDisposal of your old appliance Energy saving tipsContents Consumption data Technical data Correct use Technical safetyPage Operation Using accessories Safety with childrenDisposal of your old machine Control panel PC indicator lightProgramme selector Programme sequence and check lampsTips on drying Care symbolsBrief instructions How to dry correctlySort the laundry Turn on the tumble dryerSelect a programme Low temperatureStart the programme Changing the programme sequence Programme chart Timed drying AutomaticWarm air Cool airEmptying the condensed water container Cleaning and careCleaning them whilst dry Cleaning the fluff filtersCleaning them with water Cleaning the tumble dryerRemoving the condenser unit Cleaning the condenser unitChecking the condenser unit Replacing the condenser unit General problems Problem solving guideUp of fluff Problem Possible cause Remedy There is a buildLaundry is Not sufficientlyEven switches off Problem Possible cause Remedy Drying processGoes on too long or Check and fault indicator lamps Stopped, Problem Possible cause Remedy Programme hasHas come on Sequence displayChanging the lamp Appliance guarantee After sales serviceOptional accessories RepairsFront view InstallationTransporting the machine to its installation site Installation siteReplacing the lid Levelling the machine Before moving the machine again e.g. when moving houseRoom in which the dryer is located Washer dryer stackExternal condensed water outlet Setting up the drain hoseConnection to a sink drain outlet Electrical connection Non-rewireable plugs BSElectrical connection U.K Smoothing Consumption dataTechnical data Programmable functions for changing standard settings To check Programmable functionsProgrammable functions Buzzer is deactivated Activating and deactivating the buzzerBuzzer is activated Cooling down time will be five miinutes longer Extending the cooling down timeCooling down time will be ten minutes longer Cooling down time is not extendedStandard drying level is Normal+ Standard drying level is Hand iron Alteration rights reserved/0505