Miele T 4262 C operating instructions Operation

Page 7

Warning and Safety instructions

In the event of a fault or for cleaning purposes, the machine is

only completely isolated from the electiricty supply when:

it is switched off at the wall socket and the plug is withdrawn, or

it is switched off at the mains, or

the mains fuse is withdrawn.

Operation

This equipment may only be used in mobile installations such as

ships, caravans, aircraft etc. if a risk assessment of the installation has been carried out by a suitably qualified engineer.

The dryer must not be used without the fluff filters in place or if the fluff

filters are damaged in any way.

The fluff filters must be thoroughly dried after cleaning. If they are still damp or wet when replaced there is a

risk of faults occurring when the machine is used.

The dryer must not be used without the condenser unit in place.

Do not install the machine in a room where there is a risk of frost

occurring. At temperatures around freezing point the machine may not be able to operate properly.

There is a risk of damage if the condensed water is allowed to freeze in the pump, hoses and / or condensed water container.

The ambient room temperature should be between +2°C and +35°C.

If the water is drained externally through the drain hose instead of

being collected in the condensed water container, make sure the drain hose is securely attached if you hang it in a sink or basin to avoid the hose slipping and the water causing damage.

Condensed water is not drinking water. It can cause health

problems in both people and animals.

Always keep the area around the machine free of dust and fluff. Dust

drawn into the machine can, over time, cause blockages in the condenser unit.

7

Image 7
Contents Operating instructions For condenser tumble dryer T 4262 C Energy saving tips Caring for the environmentDisposal of the packing material Disposal of your old applianceContents Consumption data Technical data Correct use Technical safetyPage Operation Using accessories Safety with childrenDisposal of your old machine Programme sequence and check lamps PC indicator lightControl panel Programme selectorTips on drying Care symbolsTurn on the tumble dryer How to dry correctlyBrief instructions Sort the laundrySelect a programme Low temperatureStart the programme Changing the programme sequence Programme chart Cool air AutomaticTimed drying Warm airEmptying the condensed water container Cleaning and careCleaning them whilst dry Cleaning the fluff filtersCleaning them with water Cleaning the tumble dryerRemoving the condenser unit Cleaning the condenser unitChecking the condenser unit Replacing the condenser unit General problems Problem solving guideNot sufficiently Problem Possible cause Remedy There is a buildUp of fluff Laundry isEven switches off Problem Possible cause Remedy Drying processGoes on too long or Check and fault indicator lamps Sequence display Problem Possible cause Remedy Programme hasStopped, Has come onChanging the lamp Repairs After sales serviceAppliance guarantee Optional accessoriesFront view InstallationTransporting the machine to its installation site Installation siteReplacing the lid Washer dryer stack Before moving the machine again e.g. when moving houseLevelling the machine Room in which the dryer is locatedExternal condensed water outlet Setting up the drain hoseConnection to a sink drain outlet Electrical connection Non-rewireable plugs BSElectrical connection U.K Smoothing Consumption dataTechnical data Programmable functions for changing standard settings To check Programmable functionsProgrammable functions Buzzer is deactivated Activating and deactivating the buzzerBuzzer is activated Cooling down time is not extended Extending the cooling down timeCooling down time will be five miinutes longer Cooling down time will be ten minutes longerStandard drying level is Normal+ Standard drying level is Hand iron Alteration rights reserved/0505