Miele T 4262 C operating instructions Check and fault indicator lamps

	Problem solving guide
Problem	Possible cause	Remedy
The condenser unit	The inner cover of the	– Ensure that the condenser
service panel will not	condenser unit has not	unit is positioned correctly
shut.	been locked properly	and lock the cover.
	and/or the condenser	– Check the rubber seals.
	unit has not been
	positioned correctly.
Water leaks from the	Fluff has collected at	– Use a cloth to remove any
machine after the	the bottom of the	fluff from the inside of the
condenser unit has	condenser unit housing.	condenser unit housing.
been cleaned.
Check and fault indicator lamps
Problem	Possible cause	Remedy
The Empty out	The condensed water	– Empty out the condensed
container indicator	container is full or there	water container.
lamp comes on.	is kink in the drain hose.	– Check the drain hose.
		– Before starting a new
		programme, first switch the
		dryer off and then on again.
The programme has	There is no obvious	– Switch off the dryer.
been interrupted, the	cause.	– Then switch the dryer back
indicator lamp for		on and start the programme
Hand iron or Machine		again.
iron is flashing, and		If the programme stops again
the buzzer sounds.
		and an indicator lamp flashes,
		there is a fault. Contact the
		Miele Service Department.

25