GE WBVH5200 operating instructions Location of Your Washer, ROUGH-IN Dimensions

Installation Instructions

LOCATION OF YOUR WASHER

Do Not Install the Washer:

1.In an area exposed to dripping water or outside weather conditions. The ambient temperature should never be below 60°F (15.6°C) for proper washer operation.

2.In an area where it will come in contact with curtains or drapes.

3.On carpet. The floor MUST be a hard surface with a maximum slope of 1/2″ per foot (1.27 cm per 30 cm). To make sure the washer does not vibrate or move, you may have to reinforce the floor.

NOTE: If floor is in poor condition, use 3/4″ impregnated plywood sheet solidly attached to existing floor covering.

IMPORTANT:

Minimum Installation Clearances

•When installed in alcove: Sides, Rear, Top = 0″ (0 cm)

•When installed in closet: Sides, Rear, Top = 0″ (0 cm), Front = 1″ (2.54 cm)

•Closet door ventilation openings required:

2 louvers each 60 square in. (387 cm2), located 3″ (7.6 cm) from top and bottom of door

ROUGH-IN DIMENSIONS
FRONT
27.0”	2.2”
(68.6 cm)
	(5.6 cm)
20.4” (51.9 cm)
ELECTRONIC TRANSPARENT VISOR
	40.6”*
	(103.1 cm)
SIDE
30.6”	1.6”
	(3.9 cm)
(77.7 cm)
	40.6”*
	(103.1cm)
	39.1”
	(99.2 cm)
*NOTE: With pedestal, 52.6”
Stacked, 84”

15