Maytag 120 V, 60 HZ COIN/DEBIT Option, Price Suppression Option, Clear Escrow Option

Page 13

CODEEXPLANATION

COIN/DEBIT OPTION

Both coin & debit selected.

Coins selected, debit disabled. Press the LOWER RIGHT key pad for this selection.

Debit Card selected, coins disabled. Press the LOWER RIGHT key pad for this selection.

Enhanced Debit is self-selected when a Generation 2 card reader is installed in the washer. The Ed option cannot be manually selected or deselected.

Press the LOWER MIDDLE key pad once to advance to next code.

PRICE SUPPRESSION OPTION

This option causes the customer display to show ‘ADD’ or ‘AVAILABLE’ rather than the amount of money to add. (Used mainly in debit installations.)

Not Selected ‘OFF’.

Selected ‘ON’. Press the LOWER RIGHT key pad once for this selection.

Press the LOWER MIDDLE key pad once to advance to next code.

CLEAR ESCROW OPTION

When selected, money held in escrow for 30 minutes without further escrow or cycle activity will be cleared.

Selected ‘ON’.

Not selected ‘OFF’. Press the LOWER RIGHT key pad once to deselect this selection.

Press the LOWER MIDDLE key pad once to advance to next code.

PENNY INCREMENT OFFSET

This represents the penny increment price offset used in Generation 2 (Enhanced Debit) PR models. Choose from 0-4 pennies by pressing the LOWER LEFT key pad.

Press the LOWER MIDDLE key pad once to advance to next code.

If cycle counter (90C) is selected, the following is true:

100

Represents the number of cycles in HUNDREDS.

1 02 = 200

200

Represents the number of cycles in ONES.

 

2 25 = 225

TOTAL CYCLES = 225

This is “VIEW ONLY” and cannot be cleared.

Press the LOWER MIDDLE key pad once to advance to next code.

If money counter (1.0C or 1.C0) is selected, the following is true:

300

Number of dollars in HUNDREDS.

3 01 = $100.00

400

Number of dollars in ONES.

4 68 = $168.00

500

Number of CENTS.

5 75 = $100.75

 

 

TOTAL = $168.75

END OF SET-UP PROCEDURES

EXIT FROM SET-UP MODE

PD Models: Reinstall access door.

PR Models:

Unplug washer or disconnect power.

Open console, reinsert plug into AA1, close console.

Plug in washer or reconnect power.

13

Image 13
Contents W10135312B Instructions D’INSTALLATION DE LA Laveuse CommercialeWasher Safety Table of ContentsTools and Parts Installation RequirementsLocation Requirements Tools neededDrain System Minimum Installation ClearancesStandpipe Drain System Recommended Ground Method Electrical RequirementsRemove Shipping Strap Installation InstructionsConnect the Hoses Connect the inlet hoses to the washerLevel the Washer Install the front leveling feetConnect the inlet hoses to the water faucets Level the washer Complete InstallationTypical full load sizes Operating TipsMoving the Washer to a New Location If you need assistancetanceElectronic Controls Setup Wash Length Regular Cycle PriceRinse Cycles Cycle Counter Option0 TIME-OF-DAY CLOCK, Hours 0 TIME-OF-DAY CLOCK, MinutesSpecial Price Start Hour Special Price Stop HourCOIN/DEBIT Option END of SET-UP ProceduresPrice Suppression Option Clear Escrow OptionItems Maytag will not PAY for Limited Warranty on PartsDisclaimer of Implied Warranties Limitations of Remedies Votre sécurité et celle des autres est très importante Sécurité DE LA LaveuseExigences d’emplacement Exigences D’INSTALLATIONOutillage et pièces Outils nécessairesSystème de vidange avec tuyau de rejet à légout Système de vidangeDégagements de séparation minimums à respecter Spécifications électriques Méthode recommandée de mise à la terreEnlever la sangle d’expédition Instructions DinstallationRaccordement des tuyaux Connecter les tuyaux dalimentation à la laveuseRéglage de laplomb de la laveuse Installation des pieds de réglage de l’aplomb avantConnecter les tuyaux dalimentation aux robinets deau Réglage de l’aplomb de la laveuse Achever linstallationSi vous avez besoin d’assistance En cas de déplacement de la laveuse à un nouvel emplacementType de Suggestion de Charge Chargement Laveuse Commerciale Opérations DE Base Réglage DE LA Commande ÉlectroniqueCodes DE Paramétrage Pour Quitter LE Mode DE Paramétrage Page Maytag NE Paiera PAS Pour Garantie Limitée SUR LES PiècesW10135312B