JVC KD-SH9101, KD-SH9104 Searching a station manually Manual search, Select the band FM1 3, AM

To tune in FM stations only with strong signals—LO/DX (Local/Distant)

While searching FM stations (including SSM— see page 12), this unit stops searching whenever it detects signals (DX mode: The DX indicator is lit—initial setting). If received signals are weak, you may only hear noises.

By setting LO/DX to “Local,” you can make this unit detects only stations with sufficient signal strength.

1 Press MODE (M) while listening to	MODE
an FM stereo broadcast.		M
“Mode” appears on the display, and
the number buttons start flashing.

See page 40 for this function.

2Press number button 2, while “Mode” is still on the display.

Each time you press the button, the “LO/DX” setting alternates between “Local” and “DX.”

Searching a station manually: Manual search

1 Select the band (FM1 – 3, AM).

SRC	1 Press SRC (source)
	repeatedly to select the tuner.

2Press and hold SRC for more

than 1 second.

AM FM1 3 Within about 5 seconds, press

	SRC again.
FM3 FM2	Each time you press the
	button, the band changes.

Note:

This receiver has three FM bands (FM1, FM2, FM3). You can use any one of them to listen to an FM broadcast.

2 Press and hold ¢ or 4until “Manual Search” appears on the display.

ENGLISH

1 2 3 4 5 6

After about 5 seconds

The display returns to the source indication

screen.

LO indicator appears

3 Tune in to a station you want while “Manual Search” is still on the display.

Press ¢ to tune in to stations of higher frequencies.

Press 4 to tune in to stations of lower frequencies.

•If you release your finger from the button, the manual mode will automatically turn off after about 5 seconds.

•If you hold down the button, the frequency keeps changing (in 50 kHz intervals for FM and 9 kHz intervals for AM—MW/LW) until you release the button.

11