JVC KD-SH9103 manual Sound Adjustments, Settings, Adjust the level, Canceled Vol Adj BBE Sub Out

SOUND ADJUSTMENTS

Performing the basic sound	2 Adjust the level.
settings	To adjust fader and balance—Fad, Bal:

ENGLISH

You can set the speaker output balance, subwoofer output level, and input level of each source.

•There is a time limit in doing the following procedure. If the setting is canceled before you finish, start from step 1 again.

1 Press SEL (select) repeatedly to show one of the basic sound setting (SEL) screens.

Each time you press the button,

SEL the adjustable items change as

follows:

Make these two adjustments at the same time.

•If you are using a two-speaker system, set the fader level to “00.”

• Press 5 (up) or ∞ (down) to adjust the fader.

•Press ¢ or

4 to adjust the

balance.

DSP iEQ Fad/Bal

Basic sound settings

To adjust subwoofer output—Sub Out:

This takes effect only when a subwoofer is connected.

Canceled Vol Adj BBESub Out

ATT

To increase the level.

•For DSP mode settings, see pages 32 to 34.

•For iEQ (sound mode) settings, see pages 35 and 36.

Indication	To do:	Range
Fad	Adjust the front	R06 (Rear only)
	and rear speaker
	balance.	F06 (Front only)
Bal	Adjust the left	L06 (Left only)
	and right speaker
	balance.	R06 (Right only)
Sub Out	Adjust the	00 (min.)
	subwoofer output
	level and cutoff	08 (max.)
	frequency level.	Low/Mid/High
BBE	Make sounds	BBE Off, BBE 1,
	natural.	BBE 2, BBE 3
Vol Adj	Adjust and store	–05 (min.)
	the input level
	of each source.	+05 (max.)

To decrease the level.

You can also set an appropriate cutoff frequency level according to the subwoofer connected.

•Press ¢ or 4 to select “Low,” “Mid,” or “High.”

Low: Frequencies higher than 50 Hz are cut off to the subwoofer.

Mid: Frequencies higher than 80 Hz are cut off to the subwoofer.

High: Frequencies higher than 115 Hz are cut off to the subwoofer.

37