JVC KD-SH9101, KD-SH9104 manual Select a character, Move the cursor to the next, Until you finish

SEL

To erase the entered characters

Insert spaces using the same procedure described above.

Notes:

Finish the procedure while the last selected character is flashing.

6 Repeat steps 3 to 5 entering the name.

7

Assigning names to the sources

You can assign names to CDs (both in this unit and in the CD changer), and the external component.

After assigning a name, it will appears on the display when you select the source.

Sources	Maximum number of
	characters
CDs*	Up to 32 characters (up to
	40 discs)
External component	Up to 8 characters

*You cannot assign a name to CD Text, MP3, and

WMA discs.

.

1 Select a source you want to assign a name to.

3 Select the character set you want while the first character position is flashing.

Each time you press the button,

Dthe character set changes as

DISPfollows:

A – Z			a – z		0 – 9 & symbols
(Upper case)		(Lower case)			(Numbers)
	Accented letters			Accented letters
	(Lower case)			(Upper case)

4 Select a character.

• About the available

ATT characters, see page

71.

5 Move the cursor to the next

ENGLISH

SRC

When you select a source, the

power automatically comes on.

(or previous) character position.

2 While holding DISP (D), press and hold SEL (select) for more than 2 seconds.

SEL

D

DISP

Ex.: When you select CD as the source

until you finish

•When you try to assign a name to the 41st disc, “Name Full” appears on the display, and you cannot enter the text entry mode. In this case, delete unwanted names before assignment.

•When the CD changer is connected, you can assign names to CDs in the CD changer. These names can also be shown on the display if you insert the CDs in this unit.

51