JVC KD-SH9102, KD-SH9104, KD-SH9103 Press number button 6 to enter, Further precise setting screen

ENGLISH	2 Press number button 6 to enter the
	further precise setting screen.
	6

3 Select your listening seats position.

1 2 3 4 5 6

•Press number button 1 to select “LEFT (front left)” seat.

•Press number button 2 to select “RIGHT (front right)” seat.

•Press number button 3 to select “FRONT” seats.

•Press number button 4 to select “ALL” seats.

Note:

If fader or balance has been set close to its extreme, appropriate effect may not be obtained.

4 Press number button 5 to set the number of the built-in speakers.

•Select “4ch” for the four speaker system, and “2ch” for

5

the two speaker system.

5 If you select “4ch,” rotate the control dial to select your car size.

As you rotate it, the car size

ATT changes as follows:

Compact Middle Large

•Compact: Select when the distance from the rear speakers to the listening seat position is shorten than that from the front speakers.

•Middle: Select when the distance from the rear speakers to the listening seat position is almost equal to that from the front speakers.

•Large: Select when the distance from the rear speakers to the listening seat position is longer than that from the front speakers.

Note:

If you have selected “2ch” in the previous step, you cannot select the car size.

To go back to the DSP mode selection screen,

press number button 6.

To exit from the DSP mode selection screen,

press SEL (select) repeatedly or wait for about 15 seconds.

Note:

When “4ch” is selected, rear speakers are used only to reproduce reflections and reverberations in order to creates a being-there feeling in your car compartment.

34