J. PROGRAM LOCATION 07 (PL07)
Perm Press Temp
Refer to Section V for instructions on entering program locations.
Temperature Decrease
LO Temp
PL07
Perm Press
PP°F
(Wait 3-Seconds)
150F
Perm Press
Location to be viewed/changed.
Press “Perm Press” key.
Display will read “PP°F,” “Perm Press” temperature key status for 3-seconds and then actual temperature programmed. If no change, press “Perm Press” key otherwise press “HI” or “LO” keys
and then “Perm Press.”
Temperature Increase
HI Temp
Automatically goes into PL08 Program without PL08 Display Mode
Continued on next page
Summary: Perm Press Temp is programmable from a minimum of 100° F to a maximum of 190° F in ten-degree increments or from a minimum of 38° C to a maximum of 88° C in five-degree increments. For the AD-26 and AD-295any three (3) of the selections (HI/LO/PP) are programmable from a minimum of 100° F to a maximum of 170° F in ten-degree increments or from a minimum of 38° C to a maximum of 77° C in five-degree increments.
For the AD-540 and WDA-540any three (3) of the selections (HI/LO/PP) are programmable from a minimum of 100° F to a maximum of 160° F in ten-degree increments or from a minimum of 38° C to a maximum of 71° C in five-degree increments.
