ADC AD-410 Solenoid Control, Lint Drawer / Guard Status, Optional Sprinkler Control Signals

The dryer system is divided into a number of “electrical” sections which are as follows:

1.Right Front Control Panel

The RIGHT FRONT CONTROL PANEL is located in the Right Front Control Cabinet of the dryer. This panel is the heart of the drying system, where ALL control signals interface to or from this panel. The signals that interface to this panel are too many to list here, however, they are ALL identified on TB1 of its’ schematic diagram.

2.Right Base Electrical Enclosure

The RIGHT BASE ELECTRICAL ENCLOSURE is located towards the front of the right base section. An industrial multi-pin connector is used to connect the base section control signals to the tumbler section’s main control panel. This electrical enclosure is labeled CAUTION, HIGH VOLTAGE IS PRESENT IN THIS ENCLOSURE and incorporates the following electrical devises:

•The MAIN ELECTRICAL POWER to the machine

•The ELECTRICAL CONNECTION for the “OPTIONAL” SPRINKLER CIRCUIT POWER

•The THERMAL/MAGNETIC OVERLOAD and REVERSING CONTACTOR for the TUMBLER MOTOR

•The THERMAL/MAGNETIC OVERLOAD and REVERSING CONTACTOR for the BLOWER MOTOR

3.Right Base Interface Junction Box

The RIGHT BASE INTERFACE JUNCTION BOX is located towards the rear of the right base section and is used as a central location to interface the base section electrical components to the TILTING tumbler section. An industrial multi-pin connector is used to connect the base section control signals to the tumbler section’s main control panel. The control signals incorporated in the Right Base Interface Junction Box are:

SOLENOID CONTROL

•Front Up / Front Down

•Rear Up / Rear Down

•Open Front Door

•Supply Air Enable

•Air Jet

LINT DRAWER / GUARD STATUS

TUMBLER TEMPERATURE and HI-LIMIT INFORMATION TUMBLER LEVEL SENSE

•Front Level Switch

•Rear Level Switch

OPTIONAL SPRINKLER CONTROL SIGNALS

1 4