Maytag MD98 warranty Setting Time DRY, Options

SETTING SENSOR DRY

Press "Start/Pause" or change selection below.

dryness level	options
	cycle chime loud
normal dry	remind chime OFF

regular

temperature

Step 4

Review Screen – The Review Screen lists the selected settings. At this point you may press Start/Pause to begin drying the load or select “options” for further customization of the drying cycle.

Press "Start/Pause" or change selection below.

dryness level	options
	cycle chime loud
normal dry	remind chime OFF

regular

temperature

Options

loud end

of cycle chime

continue

Step 5

Options Screen – The option choices on the left turn the options on or off. The option choices on the right show an additional screen with multiple choices. The following options may be added to customize your “sensor dry” cycle:

•“wrinkle prevent” - Intermittent tumble in room temperature air for up to 95 minutes following the dry cycle.

•“damp dry chime” - Chimes when load reaches damp dry state.

•“remind chime” - Chimes at the end of the cycle every 5 minutes for up to two hours.

•“end of cycle chime” - Chimes once when the selected dryness level is reached.

When the desired selections are made, touch “continue” to see the review screen once again.

Step 6

Review Screen – The review screen will appear once again to verify your selections. If they are correct, press Start/Pause. If they are incorrect, press the area you would like to change.

SETTING TIME DRY

Special Note: As you use the touchscreen, if you feel you are lost, press Back or Home.

	Home		Press "Start/Pause" or			Press "Start/Pause" or
			change your	selections below.		change your selection below.
sensor dry				options			Time
			time	cycle chime loud		time dry		medium cycle	chime
				remind chime ON
			45 minutes		45			45
		air fluff						minutes
time dry
		(no heat)
			regular			regular		continue
more cycles		favorites	temperature			temperature

Step 1

Select “time dry” from the Home screen. The control defaults to 45 minutes.

Step 2

Press the up and down arrows to set the appropriate number of minutes to dry the load. The time will increase or decrease in one minute increments. Press “continue” when done.

7