Maytag W10160250A, W10163136A Dryer Care, Cleaning the Dryer Location, Cleaning the Lint Screen

Page 28

4.Close the door.

5.Press the POWER button.

6.Select a timed drying cycle and temperature (see following chart). Items containing foam, rubber or plastic must be dried on a clothesline or by using the Air Fluff temperature setting.

7.You must select a time by pressing TIMED CYCLE ADJUST Up or Down. Reset time as needed to complete drying. Refer to the following table.

8.Press (and hold) START button (about 1 second).

This chart shows examples of items that can be rack dried and the suggested cycle, temperature setting and drying time. Actual drying time will depend on the amount of moisture items hold.

Rack Dry	Setting	Temp.	Time*

Wool Sweaters	Timed Dry	Low	60
Block to shape and lay flat on the drying
rack.

Stuffed toys or pillows	Timed Dry	Low	60
Cotton or polyester fiber filled

Stuffed toys or pillows	Timed Dry	Air Fluff (no	90
Foam rubber filled		heat)
Foam rubber filled

Sneakers or canvas shoes	Timed Dry	Air Fluff (no	90
		heat)

*(Minutes) Reset time to complete drying, if needed.

DRYER CARE

Cleaning the Dryer Location

Keep dryer area clear and free from items that would obstruct the flow of combustion and ventilation air.

WARNING

Explosion Hazard

Keep flammable materials and vapors, such as gasoline, away from dryer.

Place dryer at least 18 inches (46 cm) above the floor for a garage installation.

Failure to do so can result in death, explosion, or fire.

Cleaning the Lint Screen

Clean the lint screen before each load. A screen blocked by lint can increase drying time.

IMPORTANT:

■Do not run the dryer with the lint screen loose, damaged, blocked or missing. Doing so can cause overheating and damage to both the dryer and fabrics.

■If lint falls off the screen into the dryer during removal, check the exhaust hood and remove the lint.

Every load cleaning

1.The lint screen is located on the top of the dryer. Pull the lint screen toward you. Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is hard to remove.

2.Push the lint screen firmly back into place.

28

Image 28

Contents Guide D’UTILISATION ET D’ENTRETIEN W10160250ATable of Contents Table DES MatièresDryer Safety Your safety and the safety of others are very importantTools and Parts Installation InstructionsLocation Requirements Mobile home Additional installation requirements Mobile home installations requireElectrical Requirements U.S.A. Only It is your responsibilityIf connecting by direct wire If your outlet looks like thisElectrical Requirements Canada Only Power Supply Cord Direct Wire Electrical Connection U.S.A. OnlyStyle 1 Power supply cord strain relief Style 2 Direct wire strain reliefWire connection Power supply cord Wire connection Direct Wire 5cmBDE CG F Optional 3-wire connection Venting Requirements If using an existing vent systemIf this is a new vent system Vent material Plan Vent System ExhaustInstall Vent System Alternate installations for close clearancesVent system chart Special provisions for mobile home installationsConnect Vent Install Leveling LegsConnect Inlet Hose Level Dryer Remove the door assemblyReverse Door Swing Reinstall the door Reverse the strikeComplete Installation U.S.ACanada If the dryer will not start, check the followingDryer USE Starting Your DryerTo use a Sensor Dry Cycle To make changes during a Sensor Dry CycleHow the Sensi-Care Drying System Works To use a Timed CycleStatus Lights Stopping, Pausing or RestartingDrying and Cycle Tips Cycles Modifiers End of Cycle Signal OptionsChanging the Preset Dryness Level Settings Changing Cycles, Modifiers and OptionsDrying Rack Option Changing Cycles after pressing StartCleaning the Dryer Location Cleaning the Lint ScreenEvery load cleaning Dryer CareCleaning the Dryer Interior Removing Accumulated LintWater Inlet Hoses Vacation, Storage and Moving CareFor direct-wired dryers Reinstalling the dryerChanging the Drum Light To change the drum lightTroubleshooting Dryer OperationDryer Results Are fabric softener sheets blocking the grille?Is the exhaust vent the correct length? Is the dryer located in a closet?Cycle time too short Lint on loadStains on load or drum Loads are wrinkledAssistance or Service AccessoriesU.S.A CanadaMaytag Corporation Major Appliance Warranty ONE Year Limited WarrantySécurité DE LA Sécheuse Votre sécurité et celle des autres est très importanteConservez CES Instructions Exigences d’emplacement Instructions D’INSTALLATIONOutillage et pièces Linstallation dans une maison mobile exige Dimensions de la sécheuseDégagements de séparation à respecter Spécifications électriques Pour le Canada seulement ’est à l’utilisateur qu’incombe la responsabilité deExigences concernant lévacuation En cas dutilisation du système dévacuation existantPlanification du système d’évacuation ÉvacuationAutres installations où le dégagement est réduit Déterminer litinéraire dacheminement du conduitTableau des systèmes dévacuation Nombre de Type de Clapets de typeInstallation du système d’évacuation Installation des pieds de nivellementRaccordement du conduit d’évacuation Raccordement des tuyaux dalimentationRéglage de laplomb de la sécheuse Dépose de la porte Inversion du sens douverture de la porteInversion de la gâche Réinstallation de la porte Installer d’abord ces visAchever linstallation Si la sécheuse ne démarre pas, vérifier ce qui suitUtilisation DE LA Sécheuse Mise en marche de la sécheuseFonctionnement du système de séchage Sensi-Care Utilisation dun programme de séchage par détectionUtilisation dun programme minuté Arrêt, pause ou remise en marche Conseils pour le séchage et les programmesTémoins lumineux ProgrammesPréréglages des programmes de séchage par détection Programmes Steam vapeurCustom Refresh rafraîchissement personnalisé Programmes minutésModificateurs Signal de fin de programme Changement des programmes, modificateurs et OptionsOption de grille de séchage Utilisation de la grille de séchageSéchage sur grille Réglage Temp Durée Chandails en laine Jouets rembourrés ou oreillersNettoyage de lemplacement de la sécheuse Entretien DE LA SécheuseNettoyage du filtre à charpie Nettoyage de l’intérieur de la sécheuseTuyaux darrivée deau Retrait de la charpie accumuléeEntreposage ou un déménagement Dépannage Fonctionnement de la sécheuseLa sécheuse est-elle installée dans un placard? Résultats de la sécheuseLe filtre à charpie est-il obstrué de charpie? Le conduit dévacuation a-t-il la longueur appropriée?Temps de programme trop court Charpie sur la chargeTaches sur la charge ou sur le tambour Charges avec faux plisAssistance OU Service AccessoiresAu Canada Si vous avez besoin de pièces de rechangeGarantie DES Gros Appareils Ménagers Maytag Corporation W10160250A SP PN W10163136A Tous droits réservés