Maytag W10163136A manual Cleaning the Dryer Interior, Removing Accumulated Lint, Water Inlet Hoses

Page 29

As needed cleaning

1.Roll lint off screen with your fingers.

2.Wet both sides of lint screen with hot water.

3.Wet a nylon brush with hot water and liquid detergent. Scrub lint screen with the brush to remove residue buildup.

4.Rinse screen with hot water.

5.Thoroughly dry lint screen with a clean towel. Insert lint screen back into dryer.

Cleaning the Dryer Interior

1.Apply a liquid, nonflammable household cleaner to the stained area of the drum and rub with a soft cloth until stain is removed.

2.Wipe drum thoroughly with a damp cloth.

3.Tumble a load of clean cloths or towels to dry the drum.

NOTE: Garments that contain unstable dyes, such as denim blue jeans or brightly colored cotton items, may discolor the dryer interior. These stains are not harmful to your dryer and will not stain future loads of clothes. Dry unstable dye items inside out to avoid transfer of dye.

Removing Accumulated Lint

From Inside the Dryer Cabinet

Lint should be removed every 2 years, or more often, depending on dryer usage. Cleaning should be done by a qualified person.

From the Exhaust Vent

Lint should be removed every 2 years, or more often, depending on dryer usage.

Water Inlet Hoses

Replace inlet hoses and hose screen after 5 years of use to reduce the risk of hose failure. Periodically inspect and replace inlet hoses if bulges, kinks, cuts, wear or leaks are found.

When replacing your inlet hoses, record the date of replacement.

Vacation, Storage and Moving Care

Install and store your dryer where it will not freeze. Because some water may stay in the hoses, freezing can damage your dryer. If storing or moving your dryer during freezing weather, winterize it.

Non-Use or Vacation Care

Operate your dryer only when you are at home. If you will be on vacation or not using your dryer for an extended period of time, you should:

1.Unplug dryer or disconnect power.

2.Clean lint screen. See “Cleaning the Lint Screen.”

3.Turn off the water supply to the dryer. This helps to avoid unintended flooding (due to a water pressure surge) while you are away.

To winterize dryer

1.Unplug dryer or disconnect power.

2.Shut off water faucet.

3.Disconnect water inlet hose from faucet and drain.

To use dryer again

1.Flush water pipes. Reconnect water inlet hose to faucet. Turn on water faucet.

2.Plug in dryer or reconnect power.

Moving care

For power supply cord-connected dryers:

1.Unplug the power supply cord.

2.Shut off water faucet.

3.Disconnect the water inlet hose from faucet, then drain the hose. Transport hose separately.

4.Make sure leveling legs are secure in dryer base.

5.Use masking tape to secure dryer door.

29

Image 29
Contents W10160250A Guide D’UTILISATION ET D’ENTRETIENTable DES Matières Table of ContentsYour safety and the safety of others are very important Dryer SafetyLocation Requirements Installation InstructionsTools and Parts Mobile home installations require Mobile home Additional installation requirementsElectrical Requirements U.S.A. Only It is your responsibilityIf your outlet looks like this If connecting by direct wireElectrical Requirements Canada Only Electrical Connection U.S.A. Only Power Supply Cord Direct WireStyle 2 Direct wire strain relief Style 1 Power supply cord strain reliefWire connection Power supply cord 5cm Wire connection Direct WireBDE CG F Optional 3-wire connection If this is a new vent system Vent material If using an existing vent systemVenting Requirements Exhaust Plan Vent SystemAlternate installations for close clearances Install Vent SystemVent system chart Special provisions for mobile home installationsConnect Inlet Hose Install Leveling LegsConnect Vent Reverse Door Swing Remove the door assemblyLevel Dryer Reverse the strike Reinstall the doorU.S.A Complete InstallationCanada If the dryer will not start, check the followingStarting Your Dryer Dryer USETo make changes during a Sensor Dry Cycle To use a Sensor Dry CycleHow the Sensi-Care Drying System Works To use a Timed CycleDrying and Cycle Tips Stopping, Pausing or RestartingStatus Lights Cycles Modifiers Options End of Cycle SignalChanging Cycles, Modifiers and Options Changing the Preset Dryness Level SettingsDrying Rack Option Changing Cycles after pressing StartCleaning the Lint Screen Cleaning the Dryer LocationEvery load cleaning Dryer CareRemoving Accumulated Lint Cleaning the Dryer InteriorWater Inlet Hoses Vacation, Storage and Moving CareReinstalling the dryer For direct-wired dryersChanging the Drum Light To change the drum lightDryer Operation TroubleshootingAre fabric softener sheets blocking the grille? Dryer ResultsIs the exhaust vent the correct length? Is the dryer located in a closet?Lint on load Cycle time too shortStains on load or drum Loads are wrinkledAccessories Assistance or ServiceU.S.A CanadaONE Year Limited Warranty Maytag Corporation Major Appliance WarrantyVotre sécurité et celle des autres est très importante Sécurité DE LA SécheuseConservez CES Instructions Outillage et pièces Instructions D’INSTALLATIONExigences d’emplacement Dégagements de séparation à respecter Dimensions de la sécheuseLinstallation dans une maison mobile exige ’est à l’utilisateur qu’incombe la responsabilité de Spécifications électriques Pour le Canada seulementEn cas dutilisation du système dévacuation existant Exigences concernant lévacuationÉvacuation Planification du système d’évacuationDéterminer litinéraire dacheminement du conduit Autres installations où le dégagement est réduitTableau des systèmes dévacuation Nombre de Type de Clapets de typeInstallation des pieds de nivellement Installation du système d’évacuationRaccordement du conduit d’évacuation Raccordement des tuyaux dalimentationRéglage de laplomb de la sécheuse Inversion de la gâche Inversion du sens douverture de la porteDépose de la porte Installer d’abord ces vis Réinstallation de la porteSi la sécheuse ne démarre pas, vérifier ce qui suit Achever linstallationMise en marche de la sécheuse Utilisation DE LA SécheuseUtilisation dun programme minuté Utilisation dun programme de séchage par détectionFonctionnement du système de séchage Sensi-Care Conseils pour le séchage et les programmes Arrêt, pause ou remise en marcheProgrammes Témoins lumineuxProgrammes Steam vapeur Préréglages des programmes de séchage par détectionCustom Refresh rafraîchissement personnalisé Programmes minutésModificateurs Changement des programmes, modificateurs et Options Signal de fin de programmeUtilisation de la grille de séchage Option de grille de séchageSéchage sur grille Réglage Temp Durée Chandails en laine Jouets rembourrés ou oreillersEntretien DE LA Sécheuse Nettoyage de lemplacement de la sécheuseNettoyage du filtre à charpie Nettoyage de l’intérieur de la sécheuseEntreposage ou un déménagement Retrait de la charpie accumuléeTuyaux darrivée deau Fonctionnement de la sécheuse DépannageRésultats de la sécheuse La sécheuse est-elle installée dans un placard?Le filtre à charpie est-il obstrué de charpie? Le conduit dévacuation a-t-il la longueur appropriée?Charpie sur la charge Temps de programme trop courtTaches sur la charge ou sur le tambour Charges avec faux plisAccessoires Assistance OU ServiceAu Canada Si vous avez besoin de pièces de rechangeGarantie DES Gros Appareils Ménagers Maytag Corporation Tous droits réservés W10160250A SP PN W10163136A