9.Attach other end of long hose to fill valve at bottom of dryer back panel. Screw on coupling by hand until it is seated on fill valve connector.
10.Using pliers, tighten the coupling an additional
11.Check that the water faucets are on.
12.Check for leaks around “Y” connector, faucet, and hoses.
LEVEL DRYER
Check the levelness of the dryer by first placing a level on the top of the dryer near the console.
Then, by placing a level in the crease on the side of the dryer between the top of the dryer and the dryer cabinet, check the levelness from front to back.
If the dryer is not level, prop up the dryer using a wood block. Use a wrench to adjust the legs up or down and check again for levelness.
COMPLETE INSTALLATION
1.Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.
2.Check that you have all of your tools.
3.Dispose of/recycle all packaging materials.
4.Check the dryer’s final location. Be sure the vent is not crushed or kinked.
5.Check that the dryer is level. See “Level Dryer.”
6.Remove the blue film on the console and any tape remaining on the dryer.
7.Wipe the dryer drum interior thoroughly with a damp cloth to remove any dust.
8.Read the “Dryer Use” section in your Use and Care Guide.
Electric Models Only
9.For power supply cord installation, plug into a grounded outlet.
Gas Models Only:
10.Check that gas supply is on.
11.Check for leaks.
All Models:
12.Select a Timed Dry heated cycle, and start the dryer. Do not select the Air Only Temperature setting.
If the dryer will not start, check the following:
■Controls are set in a running or “On” position.
■Start button has been pushed firmly.
■Dryer is plugged into an outlet and/or electrical supply is connected.
■Household fuse is intact and tight, or circuit breaker has not tripped.
■Dryer door is closed.
This dryer automatically runs an installation diagnostic routine at the start of its first cycle.
NOTE: You may notice an odor when the dryer is first heated. This odor is common when the heating element is first used. The odor will go away.
REVERSE DOOR SWING
You can change your door swing from a
1.Place a towel or soft cloth on top of dryer or work space to avoid damaging the surface.
Remove the door assembly
1.Open the dryer door.
2.Remove the bottom screw from each of the 2 hinges that attach dryer door to front panel of dryer.
12