Installation clearances | Mobile home - Additional installation requirements |
The location must be large enough to allow the dryer door to open fully.
Dryer Dimensions
This dryer is suitable for mobile home installations. The installation must conform to the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for Mobile Home Construction and Safety, Title 24, HUD Part 280) or Standard
431/2"
(1105 mm)
| 221/4" | |
291/4" | (565 mm) | |
(743 mm) | 29" | |
(737 mm) | ||
|
NOTE: Most installations require a minimum 5" (127 mm) clearance behind the dryer for the exhaust vent with elbow. See “Venting Requirements.”
Installation spacing for recessed area or closet installation
The following spacing dimensions are recommended for this dryer. This dryer has been tested for spacing of 0" (0 mm) clearance on the sides and rear. Recommended spacing should be considered for the following reasons:
■Additional spacing should be considered for ease of installation and servicing.
■Additional clearances might be required for wall, door, and floor moldings.
■Additional spacing should be considered on all sides of the dryer to reduce noise transfer.
■For closet installation, with a door, minimum ventilation openings in the top and bottom of the door are required. Louvered doors with equivalent ventilation openings are acceptable.
■Companion appliance spacing should also be considered.
|
|
| 14" máx.* |
|
|
|
|
| (356 mm) | 48" 2* |
|
18"* |
|
|
| (310 cm2) | 3"* |
|
|
|
| (76 mm) | |
(457 mm) |
|
|
|
| |
|
|
|
|
| |
|
|
|
|
| 3"* |
|
|
|
| 24" 2* | (76 mm) |
|
|
|
|
| |
|
|
|
| (155 cm2) |
|
1" | 29" | 1" | 291/4" | 5" |
|
(25 mm) | (25 mm) | (127 mm) |
| ||
(737 mm) | (743 mm) |
|
Recessed | Side view- closet | Closet door |
area | or confined area | with vents |
Mobile home installations require:
All Dryers
■Metal exhaust system hardware, which is available for purchase from your dealer.
■Special provisions must be made in mobile homes to introduce outside air into dryer. The opening (such as a nearby window) should be at least twice as large as the dryer exhaust opening.
For gas dryers
■Mobile Home Installation Kit Part Number 346764. See “Tools and Parts” section for information on ordering.
5