5.Lift the inner door assembly off of the outer door assembly. Unsnap the handle from the outer door assembly, move it to the other side, and snap in. Set the outer door assembly aside.
Reverse the hinge and hinge bracket
1.Place the inner door, screw head side up, on the work surface.
2.Remove the 4 screws that hold the hinge to the door.
3.Remove the 2 screws that hold the handle bracket to the door.
3.Reassemble the inner and outer door assemblies with the 6 screws.
4.Replace the 2 handle screws for the door handle of the door assembly.
5.Remove the plug strip or label.
Style 1: Remove the plug strip.
■Use a small
Style 2: Remove the label.
■Peel off the label located on the opposite side of the door opening covering the hinge mounting holes. Apply the label over the original hinge holes.
4.Move hinge to the other side and reattach with the 4 screws removed in Step 2.
5.Move handle bracket to the other side and reattach with the 2 screws removed in Step 3.
6.Set the inner door assembly aside.
Reinstalling the door
1.Check for fingerprints on the glass. Clean if necessary.
2.Place the inner door assembly into the outer door assembly. Align the hinge in the opening on the side. To fit correctly, the inside door assembly edge is completely inside the outside door assembly edge.
6.Insert a screw in the second opening from the top of the hinge opening and partially tighten. Hang the door by placing the top hinge keyhole over the second screw head and tighten the screw. By putting this screw in first, the door will hang in place while you insert and tighten the remaining
4 screws.
A
B
C |
A. Dryer door
B.Dryer
C.Insert this screw first.
7.Close the door and check that it latches securely.
14