PowerLogic™ PM5300 series user guide | Chapter |
Setting Up Digital Alarms
To set up digital alarms:
1.Press Dig. The digital alarm Select screen appears.
2.Press ▼ and ▲ to scroll through the list of digital alarms.
3.Press Edit to select an alarm to be configured.
4.Press Edit to select Pickup Setpoint, then press Edit.
5.Press + and - to scroll between On and Off.
6.Press OK to enter the pickup setpoint.
7.Press ▼to select Pickup Time Delay, then press Edit.
NOTE: If the selected status input mode is Demand Sync or Input Metering, a confirmation screen appears warning that if an alarm is enabled for this status input, the existing association will be broken.
8.Press + to increment the active digit through the numerals
NOTE: Units for time delays are set in seconds.
9.Press to enter the selected value for the active digit and move to the next digit to the left.
10.Continue until all values are selected, then press OK to enter the pickup time delay.
11.Press ▼ to select Dropout Time Delay, then press Edit.
12.Follow Steps 8 to 11 for the dropout time delay.
70 | © 2014 Schneider Electric All Rights Reserved |