TO SET THE ALARM
ST/SP/+
MODE | SET |
1.Press MODE to navigate to Clock mode.
2.Press SET to navigate to Alarm.
3.Press and hold SET to enter settings.
4.Press ST / SP / + to scroll upwards and COMPASS / - to scroll downwards through the setting options. The setting sequence is as follows: hour; minute.
5.Press SET to confirm.
To activate or deactivate the alarm:
•Press MODE to navigate to Clock mode.
•Press SET to navigate to Alarm and press ST / SP / + to
turn the alarm on or off. | will indicate that the alarm |
has been activated. |
|
•Press SET to confirm.
NOTE When the alarm clock is activated, it will sound at the set time every day. Press any button to stop the alarm
for that day. The alarm clock is still active and will set off again the following day.
To silence the keys:
•Press MODE to navigate to Clock mode.
•Press SET to navigate to Beep ON / OFF.
•Press ST / SP / + to silence or to turn on key sounds.
COMPASS
ABOUT THE COMPASS
The compass shows the bearing of your position in degrees due North. The outer circumference of the display consists of 60 segments that graphically show your bearing. Three lit segments represent South whereas one lit segment represents North, as shown below.
|
|
|
|
| 1. | South |
|
|
| 1 | 2. | Bearing | |
|
|
|
| ２ | ||
|
|
|
| ３ | 3. | Stopwatch |
５ |
|
|
| ４ | 4. | Cardinal point |
|
|
| 5. | North | ||
|
| |||||
|
|
|
| |||
COMPASS AND CALIBRATION
Before the compass is first used, we recommend that you calibrate the compass sensor.
To calibrate the compass sensor:
•Press MODE to navigate to the Set up mode.
EN
7