Uniden UH-100 owner manual Transmitting, Using Repeater Channels

Transmitting

The UH-100 transmits on 40 UHF CB channels. For your reference, a listing of all the available channels is printed on the back cover.

1.Select the desired channel. ego CH01

UEU

s

I{ 76.1{t?5MHz

,-, ,

LI I

2. To transmit, press the PTT switch to activate the transmitter.

.	-	..	m	MEAl		,-,	,
			RF		1
			I{ 76.1{t?5MHz			LI	I
'116.'1('5....

<e> (!D <aDS

TSQ

Note: Hold the microphone 2-4inches from your mouth and slightly to one side so that your voice does not project directly into the microphone. Speak at a normal voice level. Never raise your voice or shout into the microphone.

3.Release the PTT Switch, to end the transmission and listen for the reply.

Mal	,-,	,
s
	LI	I
I{ 76.1{t?5MHz

Using Repeater Channels

UHF CB Repeaters are used to retransmit or relay your signal. Repeaters will extend the range of your radio and overcome the shielding effect caused by solid obstructions.

In normal Simplex operation, your radio transmits on one particular frequency and receives on that same frequency. If there is a barrier (Le. valley) that partially blocks your transmitted signal, the probability of another radio receiving the signal is very

slim. Valleys, tall buildings, metallic structures, ... etc. tend to act as a screen between radios.

Standard Operation without the aid of a repeater Station

""""'-..

Normal Simplex operat~		No si~nal being
Transmitting on CH 01	'\
		Received
\	'

10